GEN 2 It sounds like a gnome slapping a tape measure around under there.

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

OP
OP
blackbird18

blackbird18

Active Member
Joined
Feb 17, 2019
Posts
61
Reaction score
35
Location
NC
Well, I got the truck back this morning. They said they looked and found nothing. Not IWE. I'll justcwait and see if it happens again.
 

06z

Full Access Member
Joined
Feb 9, 2013
Posts
569
Reaction score
838
Location
So Cal
IWE. If it's a metal sounding noise from under the driver, that goes away after you let up on the gas, it's likely the vacuum check valve. It's about a $9 part. I had this repaired on a 2020 Raptor after 26 miles. There's a TSB 19-2252. I took mine in, and after the fix, no more noise. You can test by putting your truck into 4x4A mode. This will make the sound go away. It's an extremely common issue, so your dealer will likely have the part in stock.


I had this exact issue. The dealer replaced all of the IWE components except the check valve. :doh2: The issue was still there. I bought 2 of the valves and it was fixed. Now I keep a spare in the glovebox.
 

TXRaptor

FRF Addict
Joined
Sep 15, 2010
Posts
1,851
Reaction score
1,047
I had this exact issue. The dealer replaced all of the IWE components except the check valve. :doh2: The issue was still there. I bought 2 of the valves and it was fixed. Now I keep a spare in the glovebox.

Hold it! You also had a Gnome Slapping sound under your truck? I wonder if it is contagious...
 

everetto

Member
Joined
Sep 14, 2020
Posts
24
Reaction score
30
Location
Central New Mexico
I vote for the heat shield theory. Had a similar sound from the rear. Heat shield was vibrating against tailpipe.
I have a "rattle" that to me sounds like a heat shield vibrating against something. It seems to happen most often at slow speeds, like 10-20 mph, at a fairly constant and partial throttle setting, and typically between 1500 and 2000 rpm. If I slow down a bit or speed up a bit it goes away. One time I heard it repeat in a higher gear once I reached the similar rpm. It just feels/sounds like a resonant vibration within a narrow rpm range. I have not yet been able to determine if it is coming from the front or the rear of the truck. I plan on getting under the truck and shaking and banging on everything in sight. It does not sound like any of the IWE vids I have seen and I certainly don't hear it at speeds above about 30 mph.
 
Top