GEN 2 Black lug nuts

[vazo]

Installed Mcgard lugnuts today, have a vinyl cap for the keyed lugnut- last up to salt conditions. Well made.

View attachment 127690

View attachment 127691

Where did you buy them from and do you have a part number for the lug nuts or size/specs?

Sent from my SM-G960W using Tapatalk

 

[Badgertits]

Ya, those are the ones I want.

Thanks for posting. I’m sold now.

One question tho: How well do the lugnuts seat in the holes?

Well my damn stock ones weren’t tight but had it in the shop for wax/oil change recently. I torqued these down to 150 lbs will check back in a couple days see how they hold.

 

[Badgertits]

Where did you buy them from and do you have a part number for the lug nuts or size/specs?

Sent from my SM-G960W using Tapatalk

Summit racing MCG-84622

 

[Badgertits]

Figured I’d report back- yes the Mcgard lugnuts I installed are “narrower” @ the base than the stock ones, but the wheels are forged & can take a lot of pressure, if properly torqued to 150 lbs I don’t think there should be an issue there’s still probably like 1/3”-1/2” @ least of contact all around the circumference of the lugnuts & where it sets against the wheel/hole. Plenty of bite.

And for factual proof I drove 350 miles on em over 2 days (chest up cool down cycles + humidity changes from
Being parked overnight outside) - mostly highway but I did drive up over curbs/sidewalks a number of times doing 3 point turns, one time I didn’t mean to & nailed a curb pretty good making wide turn. Also had about 7 miles on rutted crushed stone road where I drove fairly fast & hit some good potholes.

They barely backed out. It’s normal for new lugnuts to back off a bit once first installed & recommended to check again anyhow- these barely backed off just required a hard pull w/ a torque wrench w/ cheater pipe around it &
Only 1/2 needed it.

 

[pastorwug]

Well my damn stock ones weren’t tight but had it in the shop for wax/oil change recently. I torqued these down to 150 lbs will check back in a couple days see how they hold.

150 ft.lbs. !
Really?
I've always been using 100 ft.lbs.
Who or what suggested 150 Ft.lbs.?

 

[JohnyPython]

150 ft.lbs. !
Really?
I've always been using 100 ft.lbs.
Who or what suggested 150 Ft.lbs.?

OM says 148 ftlbs.

 

[Kahuna]

150 ft.lbs. !
Really?
I've always been using 100 ft.lbs.
Who or what suggested 150 Ft.lbs.?

The owner's manual.

 

[pastorwug]

The owner's manual.

Hmmm, guess I better read that!

 

[500mag]

Getting some put on today, Gorilla brand.

 

[Bigs125]

Any issues or concerns using the McGard lugnuts? Don't wanna have any issues with seating, etc., or other problems with fitment.