What did u do to your raptor today?

[DesaRaptor]

DAMN, need that for all that mall crawling you do? Engine bay is spotless.

These malls here are pretty rough, you never know when it could come in handy.

 

[madmex]

Did a few small MODs: Installed the OEM ECU connector cover. A very functional but a cheaply made component. This item is a perfect candidate for someone to offer in an aftermarket improved form. Perhaps a reversed cast Carbon Fiber version or even 3-D printer version would be desirable to me. The dealer wants $46.00 and its made of some sort of polystyrene... I found one on eBay for $20, but its still a poor value. I also did the Garage door opener visor upgrade, bought the whole visor also from eBay. And finally the drivers side frame wire harness move. That took only about 2 minutes.



R,

HAP

Do you happen to have a link? Can't seem to find it by part number.

 

[colticus]

Here's a quick of the drivers door.



The little Sony tags come off. They're just held in place by some little bent over pins that all broke off when I removed them. So when I reinstalled them I bent over the middle centering pin and hit them with a little epoxy.

That looks good.
Just regular spray paint?

 

[AdamsPolishes]

Fixed some scratches in a couple areas.

Here's a before photo:




Used the Cyclo Polisher and Correcting Polish to remove the scratches, then used Finishing Polish to get all the shine back on.




After cleaning up with some Waterless Wash, applied a coat of Paint Sealant to the polished areas.

-Dan

 

[fjcoop]

Did a 50K service. Noticed that a have torn dust boot on the driver side steering arm. Not sure what you call it. Do you think my ESP will cover it?

 

[HAP]

Do you happen to have a link? Can't seem to find it by part number.

Do you mean for the connector cover? If so, I just happened to find one on eBay. You can order from a dealer...

 

[SVTLOPEZ]

Its the little things... Still not done trimming the over lay but I love it. Good job josh with these decals

 

[Floyd91]

That looks good.
Just regular spray paint?

I ended up using rustoleum satin black after going to 4 different places looking for krypton fusion. I did a few light coats on the front and edges and then one on the back just to be sure everything was coated.

 

[t_j]

New uniballs upper and lower on the passenger side, that AGM uniball tool is worth is weight in gold. Drivers side tomorrow morning.

 

[Yukon Joe]

Did a 50K service. Noticed that a have torn duct boot on the driver side steering arm. Not sure what you call it. Do you think my ESP will cover it?

I doubt it. The tie rod boots are about $30 a piece.

New uniballs upper and lower on the passenger side, that AGM uniball tool is worth is weight in gold. Drivers side tomorrow morning.

Do you have stock control arms?

@Yukon Joe
www.runraptorrun.com