What did u do to your raptor today?

[Mjolnir]

Singles not holding right @ducatisps?

they are setup for duals up top and singles below, although Corey could probably weld the eyelets for just singles, I wanted something beefier. ended up working out great.

 

[Crikk]

Had a blast with the Chicago crew today! Thanks again.

 

[RaptorScrew]

I personally didn't do anything to my raptor today but @Kmandoske showed me what is GOING to be done to my raptor today!

He's putting my Aux Switch Panel together this weekend to handle all my extras!

 

[Crikk]

 

[CP RAPTOR]

Hauled the sled to do some much needed snowmobiling, 6 tanks of gas in 24 hours not including the truck... 'twas a good weekend finally.

 

[CoronaRaptor]

Hauled the sled to do some much needed snowmobiling, 6 tanks of gas in 24 hours not including the truck... 'twas a good weekend finally.

Especially since its been so damn cold out your way. I have a lot of family in oyur neighbourhood, they all complaining about using ice picks to clear there driveways, lol.

 

[Jimbo]

@t_j welding up our guessets.

@Kmandoske @Big Blue @mnblly and @Sitdown will show up sometime.... Maybe he'll bring us lunch

 

[CoronaRaptor]

@t_j welding up our guessets.

@Kmandoske @Big Blue @mnvlly

pics or its not happening!

 

[Jimbo]

pics or its not happening!

Added

 

[Yukon Joe]

I'll give you a good deal on an SVC Light Tower. Has flag pole mounts though.

View attachment 61202

freedommotorsports.us

Phone: 260-444-7503
Email: [email protected]

​

@Labraptor has flag holders on his wsi bar as well. So that would be an inventive.

Discovered two inch thick ice isn't enough, fell two feet straight down, then powered out. Love this truck!
View attachment 61443

Bad ass!

Pics! Probably gonna buy his set myself

Hit @Rookie up. He is selling his set up.

I was planning on purchasing a set of wheel speed detector protectors, but I wanted them to be stainless steel. Ended up fab'ing a set to my spec's. I added some extra rubber tubing to the sensor wire to prevent chaffing on the protector. Took about 2 hours to build and install. As for the bolt, I like the OEM flange type head for better clamping surface area.

R,
HAP

Really nice job! Wish mine where stainless. I'm sure you could sell those if you wanted.

I personally didn't do anything to my raptor today but @Kmandoske showed me what is GOING to be done to my raptor today!

He's putting my Aux Switch Panel together this weekend to handle all my extras!

Love the switches!