Lead Frame Recall 06-14-2024

[Nesc204]

That was $1100 to drain a 6R80, drop the pan & valve body, swap in a "new" leadframe, button it all up, plug in their computer, & push the "Fix it so it Won't Explode" button?

That's what I paid. When I looked up the repair on you tube, it is absolutely something I could do myself if I had a lift and except for the flushing part. The dealership I go to for repairs has my full trust. Been going there for 27 yrs and never had a problem

 

[Bozz]

That was $1100 to drain a 6R80, drop the pan & valve body, swap in a "new" leadframe, button it all up, plug in their computer, & push the "Fix it so it Won't Explode" button? That's reasonable, since it's three gallons of tranny juice @$7/qt... and they warranty their work. Did they recommend a different cooler than oem?

Did mine myself for about $300. Well.....@Gumby did 99% of it.

 

[Nesc204]

That was $1100 to drain a 6R80, drop the pan & valve body, swap in a "new" leadframe, button it all up, plug in their computer, & push the "Fix it so it Won't Explode" button? That's reasonable, since it's three gallons of tranny juice @$7/qt... and they warranty their work. Did they recommend a different cooler than oem?

No mention of a different cooler. But then again I never looked into one cause I never had temperature problems with mine

 

[Ricoman]

It actually is a slow problem. The problem is that the older Lead frame gets small metal particles that get on the contacts and causes them to short out. I have always kept up with the recommended tranny flush and mine crapped out at 190,000 miles. Big yellow wrench came up on the screen and it dropped down to 3rd gear and I limped it home. The new molded lead frame has a basically a filter on top of the contacts to prevent them from shorting out. Another type has a magnet that traps the debri

Great info as always from this site.
Good to know,and funny,since i was scheduling Tranny and cooling service,plugs,wires,brakes and shocks with my trusted mechanic next month,even though most is not scheduled with only 75k on it..except shocks...
Can you tell i love my baby and never gonna sell..
Thanks for the info

 

[TomDirt]

Did mine myself for about $300. Well.....@Gumby did 99% of it. (plus another couple bucks for a new transfer seal, & bulkhead connector that my personal hero Fordtechmakuloco recommends).

 

[Nesc204]

I had them do the new seal and connector also. Saw information they can be a problem down the road so might as well replace since ya already in there

 

[TomDirt]

I had them do the new seal and connector also. Saw information they can be a problem down the road so might as well replace since ya already in there

AKA "Buy once, Cry once".