JLT oil separator

[skyscraper]

I drained mine again after 500 miles and got a few ounces. What's so much better about the rev extremem other than capacity? Will it trap more? Or is it just for convenience? I have yet to see any proof it works better, just opinions. I have no brand loyalty in this, I'd rather get the best one, but I dont see any proof that one is better than the other. They all seem to do the job, the JLT just has to be drained often.

 

[SilentShooter]

I just see the JLT as the simplest solution as its the really only true plug and play option.
Mine has been doing its job and could not be happier with it.

 

[Yukon Joe]

I just see the JLT as the simplest solution as its the really only true plug and play option.
Mine has been doing its job and could not be happier with it.

Yup... emptied mine tonight. Only had about 6100s miles on it and only had a little water and nastiness..... I Don't mine some engine maintenance every now and then.

Yukon Joe
www.RUNRAPTORRUN.com

 

[TheWolf]

Installed the JLT but it did not end up level like the install video shows. I tried twisting some of the fittings to get the can more level but did not help much, it seems like I would need to short the hose going to the valve cover. Is there any issue leaving it like this:

 

[locktech]

Mine sits level and rests on what's below. I thought you could level it before you install it.

 

[TheJoker]

Installed the JLT but it did not end up level like the install video shows. I tried twisting some of the fittings to get the can more level but did not help much, it seems like I would need to short the hose going to the valve cover. Is there any issue leaving it like this:

View attachment 44119

The separator will swivel, take it off if you have to. Here is a image from the installation instructions. I rotated the fittings before installing, I think that may have loosened it up so that it was easier to adjust once it was installed.

Locktech, that's your coil pack.

 

[J DAMAGE]

Installed the JLT but it did not end up level like the install video shows. I tried twisting some of the fittings to get the can more level but did not help much, it seems like I would need to short the hose going to the valve cover. Is there any issue leaving it like this:

View attachment 44119

Wolf, is it the hard plastic line on your set up? if so carefully use a heat gun and bend it to your location, and cool it with a wet rag.

 

[locktech]

Wolf, is it the hard plastic line on your set up? if so carefully use a heat gun and bend it to your location, and cool it with a wet rag.

Shouldn't have to. It swivels to level it.

 

[J DAMAGE]

Shouldn't have to. It swivels to level it.

Thats what I thought, just turn the fittings, but throw it out there worst case.

 

[SilentShooter]

I was able to just rotate mine to sit level.