Installed CAI and got two fault codes

[SexyAvalancheGrey]

I installed a CAI a few days ago and got these two codes tonight:

P061A - Internal Control Module Torque PErformance

P04DB



Seems to be directly related to the CAI after my research. Seeing if anyone else had this happen and did they find a way to fix the issue or should I just cut my losses and put back the stock airbox?

 

[joegie]

which cai? did you make sure to plug the sensor back in? make sure all clamps are tight? i've ran the s&b for a few thousand miles and have not had any check engine lights.

 

[SexyAvalancheGrey]

which cai? did you make sure to plug the sensor back in? make sure all clamps are tight? i've ran the s&b for a few thousand miles and have not had any check engine lights.

Everything was properly put back together including the sensor....... I also have a Tune, Catless DP's, FMIC, Turbo Adapters.......not sure if the tune needs to be altered, I emailed my tuner......

 

[joegie]

reset the cel and see if it pops up again

 

[hammer73]

If you Dont have them already... O2 extenders on the downpipes....


18 SCrew Magnetic, Roush CAI. Whipple tuned. SPD adapters, Kooks Green catted down pipes. HF & VHF Connected.

 

[Livernois Motorsports]

Hey guys just so you know it is not the o2 sensor code you gave us for the p04db it is a crankcase vent system issue. Usually that means your current cold air is not flowing as efficient as your stock system. Ecoboost motors do not require a tune for a cold air system but can trigger this code. You either have something loose or you need to look into a different system or try stock system to see if problem persists. My name is Jake message me or call me with any questions or concerns. Thanks 313-561-5500