Search results

Some asked for more info. The Airraid setup I have is around $750, part of the high expense is that I have the cool snorkel, and had it custom anodized, without those your more around 500 or so. I got everything from Corey at RPG. Note that anodizing takes awhile, so patience is definitely...

my information is anecdotal to some degree. My Kenwood stereo system with Maestro gives me full gauge readings from my OBD sensor so I can see the MAF sensor data realtime. I also have a Solo DL so I can get accurate performance measurements. So far (early data), I'm not losing any flow...

26 is probably okay, I have cabinets that are about 30 inches deep in front of mine, still can walk around the truck Sent from my iPad using Tapatalk

Mine are 10 feet wide by eight high by 30 feet deep. I have about two feet between garages so car and truck doors can open fully Sent from my iPad using Tapatalk

Aww hell, knew this would happen. Okay, let me put something together Sent from my iPhone using Tapatalk

at the runs the CAI's were getting enough air in, but the damn things keep falling off, and the stock box gets clogged to easily, so the truck just starts dropping power the further into the event (laps) I go. UMP makes a bad ass filter. They design these things for construction tractors and...

With a little help from RPG and TMX my trucks bad asthma is cured.

BAM. Registered #11. See you guys there. Sent from my iPhone using Tapatalk

only issue I have with mine is fighting off the dead I wake up when starting on cold days. <zombies> brr....

yeah it's Corey's recommendation. right now I have National SD's that I added a leaf to and custom arched, but they are pretty much flat now. I carry between 300 and 400 pounds in the bed at all times, and I will admit I do like some air, so this is our next step. if it's too much I can...

truck is going in for some airbox, new deaver +5's, driveshaft, and of course a few more lights, cannot wait for Raptoberfest...

Some minor changes to the electronics Added a headlight controller from the Expedition to be able to control my SR series rigid and free up an up fitter switch Changed my dash cam to Blackvue so I could output it easier (thanks Joe Latigo), added a distribution block to handle my rats nest of...

I have the dual coil short throw JL 10" in my Raptor in a box that is *just* bigger than stock box. It sounds great, by running dual coil it's dropped to 2 ohms. I pair that with some ZR series 8" mid subs in the rear scab doors (that took some work). search ducatisps stereo and you'll find...

I was in SF last week and while walking down Nob hill (stayed at Mark Hopkins) I told my wife next time we drive the Raptor. I just dream of the air I would get on those hills? Sent from my iPhone using Tapatalk

my vote - linex the flares. looks nice and becomes zero maintenance.

looks better dirty. after enough times you slowly come to the realization that all Raptors are Terrain naturally, and the other colors only show through between your real drives.

i road killed my interior (like Dynamat), pulled everything out, then went to town on it. not a single squeak or rattle (other than my 3.5's clicking away out back). It's about $300 in material, or a total of around $1200 if you have a stereo shop do it. when I shut the door now it sounds...

tabletops...

on the WD40 - I do have one caution I did do this when installing my last cage setup, and after TRR, I got the nagging feeling that I should check the bed bolts, sure enough two of them were finger tight. I have seen garage sales at TRR before, but it would be impressive to see someone...

congratulations! where in Colorado?

Today I am getting the passenger seat rail on my beast replaced. I've been getting an airbag warning saying "move objects away from passenger seat". turns out with all the shenanigans at TRR I managed to shear off a bolt on the passenger seat rail! that was a first for me, but probably...

dual 3 car garages, measure out at 30 feet deep by 38 feet wide. Raptor fits in nicely with room to walk around it:

You can use the Rigid security nuts on one side, just reverse the nut/bolt arrangement. I have two security nuts on the left side, normal bolts on the right.

Thanks. ADD Raceline R in front and AdD Stealth Fighter in Rear Sent from my iPad using Tapatalk

helmet (dot) toe strap fire extinguisher quart of PS fluid quart of oil everything strapped down think that's it