91Eunos
Full Access Member
Winery tours in the Willamette Valley… De Rigueur pic from this one, for obvious reasons!
What did you do to your Raptor today? (Gen2)
- Thread starter Jepper
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
91Eunos
Full Access Member
Back from dinner…
91Eunos
Full Access Member
Passed through Moab today OTW home to Tejas
91Eunos
Full Access Member
Finally home!
Hope I still have some gas in one of my dump cans, otherwise the 10-mile drive down the hill to the nearest gas station in town is gonna be an adventure!
Hope I still have some gas in one of my dump cans, otherwise the 10-mile drive down the hill to the nearest gas station in town is gonna be an adventure!
TwizzleStix
Pudendum Inspector aka FORZDA 1
When it says 0 miles you still have about 2 gallons in the tank. I’ve driven ~15 more miles and put over 36 gallons in mine. The “rated” spec capacity and actual capacity are not the same.
Even my ‘21 ExplorerST rated at 20.2 gallons, actually will hold 21.5 when actually filled to capacity.
That said, if you stop filling at the first pump shut-off you’re leaving a lot of air in the tank and the max travel distance will be lower by some margin, depending on your driving habits. The only time filling to max capacity could be a problem with evap is if you did it and left the vehicle sitting there over night. Even then if it was cool weather it would be fine.
Even my ‘21 ExplorerST rated at 20.2 gallons, actually will hold 21.5 when actually filled to capacity.
That said, if you stop filling at the first pump shut-off you’re leaving a lot of air in the tank and the max travel distance will be lower by some margin, depending on your driving habits. The only time filling to max capacity could be a problem with evap is if you did it and left the vehicle sitting there over night. Even then if it was cool weather it would be fine.
KingKoopa17
Full Access Member
It's gonna be a busy weekend, boys...
Not pictured: "new" shocks, K02s, and new transmission fluid and filter. Haven't gotten the filter yet so I'm holding off on that til maybe next weekend. Then after that she's getting undercoated with Surface B'laster.
Not pictured: "new" shocks, K02s, and new transmission fluid and filter. Haven't gotten the filter yet so I'm holding off on that til maybe next weekend. Then after that she's getting undercoated with Surface B'laster.
ARP stainless steel bling bolts installed! 10-15 HP gain easy. I wish they were cross drilled, I would have loved to safety wire them.
KingKoopa17
Full Access Member
Just some takeoffs from a 2020 model I found for a decent price. The guy I bought them off of switched to Kings after only a few hundred miles. After the swap I'm going to give rebuilding a shot, but I haven't seen too many guides on rebuilding the live valves. I can't imagine they'd be too difficult though. If all else fails, I'm going the SDi E-Clik route and sending them out to be re-valved.
91Eunos
Full Access Member
No pic, but just changed the oil after my road trip…. One nice surprise was that the blow by in the catch can was the cleanest I’ve ever seen on my truck. It’s usually a sludgy chocolate-milkshake looking mess, this time just a nice thin oil consistency; only ~20% full too vs. usually pushing 50% full at my normal 5K(ish) change intervals.
I guess sustained higher speed running is better for the engine than stop and go traffic while commuting!
Next up: Wash the bug guts off this thing!
I guess sustained higher speed running is better for the engine than stop and go traffic while commuting!
Next up: Wash the bug guts off this thing!
Similar threads
