MudLovingFJ
Full Access Member
Added RappyGraphics center hood stripe today
What did you do to your Raptor today? (Gen2)
- Thread starter Jepper
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
Super excited to get her back from the shop. Had these goodies added to balance out the Eibach springs up front. Thanks Nick @ Apollo and Aleks @ Alekshop
Sent from my iPhone using Tapatalk Pro
Looking good, man! Hope you enjoy the new setup!
Stainless Works Dump exhaust installed!! Bumper looks much better without the exhaust sticking out..sounds great too can’t wait to hear it when it gets some carbon build up. Thanks again Nick!
Sent from my iPhone using Tapatalk Pro
That SW exhaust really cleans up the rear end. Looks sharp!
Kirby Lastinger
Full Access Member
Got my CVF intercooler installed. Definitely a well built piece. Much larger and heavier than the stock unit is.
A few tips as there are no instructions. There are a couple of good YouTube videos on the install. I will say CFV tech did respond quickly back to a question I emailed them about the shroud.
1. A floor jack is helpful with the install.
2. The shutter shroud does have to be removed.
3. Be sure and get the fans reinstalled prior to raising the IC into position, as the seats for it are above and in front of the IC mounts.
Took me about 3 hours. Would take me about 2 now that I have done it once.
.
Sent from my iPhone using Tapatalk Pro
A few tips as there are no instructions. There are a couple of good YouTube videos on the install. I will say CFV tech did respond quickly back to a question I emailed them about the shroud.
1. A floor jack is helpful with the install.
2. The shutter shroud does have to be removed.
3. Be sure and get the fans reinstalled prior to raising the IC into position, as the seats for it are above and in front of the IC mounts.
Took me about 3 hours. Would take me about 2 now that I have done it once.
.
Sent from my iPhone using Tapatalk Pro
Stock suspension and tires?Was going to remove my hooks as I didn’t like them sticking out so far with this bumper but after looking just moved them back a little instead. Turned out the back hook bolt holes and the front skid plate bolt holes in the frame line up perfectly for the hooks
Sent from my iPhone using Tapatalk Pro
Got more pics of you truck
Turbogoat324
Full Access Member
Stainless Works Dump exhaust installed!! Bumper looks much better without the exhaust sticking out..sounds great too can’t wait to hear it when it gets some carbon build up. Thanks again Nick!
Sent from my iPhone using Tapatalk Pro
looks awesome! Would you be able to take a few more pics in daytime!
Thank you very much and yes I will do some more if it ever quits raining and I can get her cleaned up ...hopefully this weekend
Sent from my iPhone using Tapatalk Pro
Some not so good ones as it needs to be cleaned badly
Sent from my iPhone using Tapatalk Pro
Last edited:
TrackRat
Full Access Member
While it was in for the rear suspension we tossed on a set of AMS turbo adaptors.
Sent from my iPhone using Tapatalk Pro
Sent from my iPhone using Tapatalk Pro
Similar threads
