Simplejack
Full Access Member
probably the best $120.42 you ever spent!
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
grab the back side of the rivet with channel locks, finish drilling it out. get plastic push pins from the hardware store to plug the holes.Installed a Swarf works license plate bracket to open up the IC grill for more air flow. Unfortunately I forgot I had inadvertently tried to screw a plate in @ the top when purchased new mistaking the rivets for holes (actually didn’t really look hard just assumed & you know what they say bout that) - so tried drilling em out but they were spinning too much to make it happen. Plan on pulling out & squishing rivet heads flat then sawing off carefully or just removing bumper & punching out @ which point may as well get it done in Linex.
The swarf plate bracket is top notch - and should be for the price. On the fence on whether to leave plate as-is or add a black “raptor” frame w/ it
View attachment 128109
View attachment 128110
View attachment 128111
View attachment 128546 View attachment 128547 Did a quick temporary plastidip on the flares of my McNeil 2+2 fenders. I will be coating them with raptor liner once they are painted the correct color and time is spent aligning them. Have to finish my wheel wells and mount Co2 tank for dirty dozen run next weekend