I will say that BD did not create a nice bracket. Reason being are the Allen head bolts. They should have used normal flat head hex nuts. That an open wrench could easily get too. They use allen head bolts. Which as you can see, you can’t tighten down easily. The big bolt that holds the bracket you can’t tighten down with the lights on the bracket. And the Allen’s head bolts cause the Allen head tool to hit the exhaust. This is a dumb design. To make matter worse. Baja designs put WAY too much loctight on the Allen bolts. So just trying to tighten them feels like you’re going to strip them out.
So my harness was top notch. The lights look nice. But the BD brackets and bolts are not well thought out at all. Complete cluster just trying to install three simple bolts. Just installing the lights to the mount took the longest by far.
Why on earth would they supply allen head bolts where you have NO room for an allen head tool? It was such a pain in the ass to get on. It’s doable. But I had to do the exhaust side bolts first, then the other side. The excessive loctight made it very difficult to get started. A normal bolt with a flat hex head would have been so much easier to tighten down. Not so much room with an Allen head and tool.
View attachment 430603