GEN 2 SVC Track Bars

[MacK88DO]

Has anyone installed a set of these? I’m definitely in the 90% on road 10% off group and I like the idea of decreasing axle hop as it is very noticeable. Just curious if you lose much ground clearance or if it affects the ride quality negatively.


Sent from my iPhone using Tapatalk

 

[Booth9999]

I think zombie slayer is the only one currently running them.

 

[diprivan1]

I’m having Rogue Racing install their traction bars, along with their cantilever suspension, on my F150. I’ll give you feedback once I test the system. They don’t inhibit rear wheel travel at all.

 

[Truckzor]

Have not seen the SVC bars yet but a lot of us supcharged gen 1 guys run the rogue racing bars. Good product. Wheel hop 100% eliminated.

 

[Turbogoat324]

The mounts have to be welded on t the axle right? I presume it’s not just a bolt on product?

 

[diprivan1]

For my (Rogue Racing) traction bars, the mounts have to be welded on the axle. Otherwise bolt on for everything else.

 

[svc]

The Mounts are welded on to the frame side, once thats done everything else bolts up. These do not effect travel and have been tested numerous miles on and offroad

 

[MacK88DO]

The Mounts are welded on to the frame side, once thats done everything else bolts up. These do not effect travel and have been tested numerous miles on and offroad

Not afraid to get some welding done. My biggest complaint with the handling on this truck is the axle hop/axle wrap. Smooth that out and I think it’ll be a huge improvement. Could y’all recommend the best approach to level the truck and complement the track bars? Not looking to go too crazy right now, but I’d be lying if I told you I haven’t been drooling over your mid travel kit... that’s a future pipe dream down the road when the trucks paid off.


Sent from my iPhone using Tapatalk

 

[svc]

The best way would be deavers track bars and the CAS. This will noticeably improve handling

 

[cwylie]

SVC - Any install instructions you can share?