Some Cobb engine dress up installed today (+Cobb Intercooler)

[Shark]

I installed the Cobb radiator shroud, overflow tank cover, and the snorkel bracket on the new Gen3 this evening. This is mostly just engine dress up, although the snorkel bracket does prevent a potential air restriction issue. Pretty simple install that took under an hour in total. Here is before and after:

 

[SoCalRey]

Ugh, I need to buy this. I add it to my cart and forget to buy it.

 

[Raptor812]

Looks good!

 

[SurfRaptor]

I just did mine the other week but my air intake sits up a little higher now. Is this an issue? @COBB Tuning

 

[COBB Tuning]

View attachment 399832
I just did mine the other week but my air intake sits up a little higher now. Is this an issue? @COBB Tuning

You're good! If you want, you can loosen up the hardware holding the shroud and snorkel tie-down and wiggle the lip of the snorkel farther towards the front of the vehicle and the shroud back a little bit. That should get it to lie flatter.

 

[SurfRaptor]

You're good! If you want, you can loosen up the hardware holding the shroud and snorkel tie-down and wiggle the lip of the snorkel farther towards the front of the vehicle and the shroud back a little bit. That should get it to lie flatter.

Thank you

 

[maxr]

Did mine a few days ago with the same stuff.

 

[Gdog]

View attachment 399832
I just did mine the other week but my air intake sits up a little higher now. Is this an issue? @COBB Tuning

Might as well get the Cobb CAI

 

[tm965]

curious if anyone has seen their intake temps drop after installing the shroud

 

[hingedthinker]

I did my Cobb Stage2 just last week. Hoping to complete logging and send to Goose today. I did the shroud too. Much better than the plastic junk. I also need to install the TS eBoV. Looking good. I noticed the battery is positioned differently in #JenTres compared to JenToo.