RPG Texas Raptor Run: TRR14 April 10-13 2014

[treypal]

Lodging Poll

http://www.fordraptorforum.com/f113/rpg-trr14-where-you-staying-32048/

 

[treypal]

TRR is proud to announce NITTO Tire as The Official Tire of the RPG Texas Raptor Run 2014 Presented by FOX. NITTO makes an awesome tire, and we're excited to have them on board for the event!

 

[iSurvive]

Couldn't find the instructions SHO-ME Strobe-Style LED Flasher

There's the link to the flasher

Sent from my XT1080 using Tapatalk

Available on Amazon. Very easy to install. The issue would be changing them from the flash pattern you want and "always on". You would have to see the lights while you adjust the pattern. Each time you give the "white" wire power, the mode changes, and you have to cycle through each pattern (seven I think) until you get to the one you want.

OR

You could hook up the flasher to the lights (leaving the white wire hooked to nothing) and add a switch for "constant on". In this case you would apply power to the white wire until you get the flash pattern you want and then leave it alone - it will stay on this pattern. The you need a special splitter (diode) that lets you feed power to the lights from the flasher module AND the switch for "constant on".

So:

a) send power to the flasher, you get strobing
b) send power to the light, you get constant on

 

[DesaRaptor]

Available on Amazon. Very easy to install. The issue would be changing them from the flash pattern you want and "always on". You would have to see the lights while you adjust the pattern. Each time you give the "white" wire power, the mode changes, and you have to cycle through each pattern (seven I think) until you get to the one you want.

OR

You could hook up the flasher to the lights (leaving the white wire hooked to nothing) and add a switch for "constant on". In this case you would apply power to the white wire until you get the flash pattern you want and then leave it alone - it will stay on this pattern. The you need a special splitter (diode) that lets you feed power to the lights from the flasher module AND the switch for "constant on".

So:

a) send power to the flasher, you get strobing
b) send power to the light, you get constant on

I used the same diode packs to wire my rear bumper lights from the trailer harness reverse lights and upfitter switch.

 

[Big Blue]

Sunrise at TRR!

 

[Yukon Joe]

Sunrise at TRR!

You heading back blue?

Yukon Joe
www.RUNRAPTORRUN.com

 

[verytalonted]

Sunrise at TRR!

Can't wait to see ya again Buddy!

 

[Big Blue]

You heading back blue?

Yukon Joe
GREAT LAKES RAPTOR EXCURSIONS

I'm soooo tempted Joe. Unfortuantely, none of my local buds want to deal with the commute and I'm not sure if I want to do it solo again...I'm an old man you know.

Can't wait to see ya again Buddy!

Hope to make it brother. We made a hell of a Beer Pong team!!

 

[Red]

Did I read it correctly that the RV spots at the ranch are sold out?

 

[treypal]

Did I read it correctly that the RV spots at the ranch are sold out?

For the time being. I am working on a solution. I should have 4-8 sites open up with at least electric, and most likely water.