Rigid 20" Lightbar & Duallys - Installation Instructions

[bulldog46]

Ya those lights look wicked on your truck. Rigid's are simply top notch. This video does a lot of justice for this product Rigid Dually D2 Series @ Cap-it - YouTube

 

[ABNRAPTOR]

I picked up a single Dually D2 Diffused as a back up light. After reading this thread I'm wondering if I'll be able to find a 2 amp fuse for switch 4. Any options here? Can I just tap into the factory backup lights? It would be nice to have the D2 come on manually and when I throw it in reverse.

 

[The Car Stereo Company]

i dont see a problem tapping into the reverse lights. if is only a 2 amp draw it will be fine

 

[ABNRAPTOR]

Will my backup/utility light work if I wire it "normally" and then just run a jumper from the power of the reverse light? I'm not much of an electrician. Is it as simple as a relay switch to avoid some sort of reverse power surge in the space time continuum?

I'm wishing I had just picked up two lights so I could throw them on an up-fitter switch!

 

[iSurvive]

Will my backup/utility light work if I wire it "normally" and then just run a jumper from the power of the reverse light? I'm not much of an electrician. Is it as simple as a relay switch to avoid some sort of reverse power surge in the space time continuum?

I'm wishing I had just picked up two lights so I could throw them on an up-fitter switch!

I don't see a connection between one or two lights and your up-fitter switch??

You can run one, two, or four lights on one switch. I'm running four Rigid Duallys on switch #2. If your concerned about fuse size, just add an inline fuse between the light and the fuse box.



Good decision using a diffused light for your backup light!

 

[justvettn]

I picked up a single Dually D2 Diffused as a back up light. After reading this thread I'm wondering if I'll be able to find a 2 amp fuse for switch 4. Any options here? Can I just tap into the factory backup lights? It would be nice to have the D2 come on manually and when I throw it in reverse.

Rigid recommends a 10 Amp fuse for one D2 and a 15 Amp fuse for two D2's.

 

[ABNRAPTOR]

I taped into the reverse light with a single diffused D2 and it works beautifully. I wish I knew enough to put it on a switch as well as being hooked to the reverse light. Maybe I can figure it out by the time i put a new rear bumper on.

 

[matrix243]

probably a stupid question but how much on-road use can you use the 20" in the lower grille?

 

[jlatigo]

non at all, the light is ridiculously bright! cars would come at you like moths to a flame!

 

[matrix243]

thats what I thought. was just trying to justify by how much use.