Interested in Shorty Headers?

[Wilson]

just saying if you ran e-30 you could have the long tubs.

 

[skyscraper]

Bump this up....I talked to Paul and SW, and he said if we can revive interest in this and get about 25 people on board to commit to this he will make a run on them. Any other california guys interested?


Edit: Obviously, not just California guys, but I figured thay Ca may have the largest market for them due to the smog issues.

 

[Dan06]

Yeah, I'm interested. The poll is close though. May need to reactivate that.

 

[cups]

I'm defiantly interested. But I will have to declare this provisionally. Recent financials may not support it.

So, maybe.

 

[Hockster]

Ok... I really think this need to be ran by SW. I did it last time and we had enough interest but only 5 ppl gave a deposit. I pm them and ask to start another with directions on what to do

 

[skyscraper]

Ok... I really think this need to be ran by SW. I did it last time and we had enough interest but only 5 ppl gave a deposit. I pm them and ask to start another with directions on what to do

Good idea. I'd like to know what they need for a deposit, and get a list of people who will post up that they will commit and give a deposit

 

[Hockster]

Good idea. I'd like to know what they need for a deposit, and get a list of people who will post up that they will commit and give a deposit

Pm sent to them. I really hope we can get this going this time

 

[skyscraper]

Pm sent to them. I really hope we can get this going this time

Same here. I may hit up a few other forums and see if there is any interest there as well. I also PM'ed SW to see if there is an estimated total price on the headers so guys will have an idea of what they will pay for them.

 

[Stainless Works]

Ok so I guess we may need to revisit this thread/poll for some shorty headers. Sorry we don't have an idea of cost, I'm sure less expensive than long tubes but not sure. We need to take a hard look at these before going in R&D then production. I will work on starting the poll tomorrow and see who is interested.

So what is the driving factor to a shorty header, easier install or cost?

 

[skyscraper]

Ok so I guess we may need to revisit this thread/poll for some shorty headers. Sorry we don't have an idea of cost, I'm sure less expensive than long tubes but not sure. We need to take a hard look at these before going in R&D then production. I will work on starting the poll tomorrow and see who is interested.

So what is the driving factor to a shorty header, easier install or cost?

First of all: thank you for taking the time to do this.

For myself the driving factor is the ability to pass smog. I want the sound and the HP gain, buy I do not want to do anything that will bite me as far as my warranty and smog goes.