Eibach Pro-lift springs installed with pics and comments

[vazo]

Absolutely! Where should I start my measurement from? Not sure what exactly is the norm in measuring for this

I think most measure in the center of the wheel to the bottom of the flare. If you could do all four wheels before that would be awesome.

Thanks

Sent from my SM-G960W using Tapatalk

 

[GR8Ride]

Just got mine delivered today, I’ll post before and after pics when I finally get them installed.

Getting Eibach’s installed next week on a my ‘19. Are you going with the Canberra bolts? I’m on the fence whether I should order them.
I will also do measurements as vazo requested.


Sent from my iPhone using Tapatalk

 

[GR8Ride]

“Camber”


Sent from my iPhone using Tapatalk

 

[Leftsidej]

“Camber”


Sent from my iPhone using Tapatalk

I was going to ask the shop I go to what they recommend on if camber bolts are a “must have”

 

[FrodoTBaggins88]

Couple more pics of my 2019 with Eibachs + Icon leaf springs on lowest setting + 1.25” wheel spacers.




Sent from my iPhone using Tapatalk

 

[Birdhuntingraptor]

^^ sweet looking truck. I’m waiting on the same setup, should be on next week. Same color truck. Any side pics?

 

[Johnkn]

FrodoTBaggins88

Looks great, are you running wheel spacers? Any comments/installation tips? I have the same truck and really like the '19 wheels, I'd just like to push mine out a little.

thanks!

 

[FrodoTBaggins88]

FrodoTBaggins88

Looks great, are you running wheel spacers? Any comments/installation tips? I have the same truck and really like the '19 wheels, I'd just like to push mine out a little.

thanks!

1.25" Faction Fab wheel spacers/adapters from Stage 3. They're identical to the Bora spacers/adapters. Would have gotten the Boras but weren't in stock at the time. Hub-centric and forged. You'd have to trim the studs about 1/4" in the rear but the front ones fit fine, no trimming needed. I put red loctite on the factory studs to bolt to the spacers/adapters and torqued to spec. Several hundred off-road miles and no issues.

 

[FrodoTBaggins88]

^^ sweet looking truck. I’m waiting on the same setup, should be on next week. Same color truck. Any side pics?

Thanks man. I don't have any straight on from the side at the moment. Next time I remember to get one I'll post it. Good luck with your build!

 

[galan.kelley]

Looks great man! Can’t wait for mine to get here this week.

Did you use aftermarket UCA’s? Or just leave it stock?


Sent from my iPhone using Tapatalk