Diving In (Interior vinyl wrap)

[Big Papa Gecko]

So, ordered and put in my weathertech floor liners, starting tomorrow, I'm going to start digging into pulling all the brushed aluminum trim to wrap. I've looked at alot of videos, hoping it goes relatively smooth! Pictures will follow!

 

[Big Papa Gecko]

Crappy picture for now, first time ever pulling a door panel, so was a learning experience. Will update tomorrow and planning on getting last 3 done.

 

[CoronaRaptor]

What vinyl is that and where did you get it?

 

[TAC71]

Not sure where OP got his from , but I have been looking at these

2013 Ford F-150 Dash Kits | Custom 2013 Ford F-150 Dash Kit

2013 Ford F-150 dash kits are an interior dash trim that installs over your 2013 Ford F-150's OEM dash parts for a custom, wood, carbon fiber or aluminum look.

www.rvinyl.com

Cant wait to see some pics

 

[Big Papa Gecko]

What vinyl is that and where did you get it?

3M 2080 vinyl, its pressure activated vice heat, and using 3m adhesion promoter for corners. I ordered it off good old amazon. Its listed as 1080 but that line is discontinued and they send the 2080.
https://www.amazon.com/dp/B009P975OQ/?tag=fordraptorforum-20

 

[Big Papa Gecko]

Not sure where OP got his from , but I have been looking at these

2013 Ford F-150 Dash Kits | Custom 2013 Ford F-150 Dash Kit

2013 Ford F-150 dash kits are an interior dash trim that installs over your 2013 Ford F-150's OEM dash parts for a custom, wood, carbon fiber or aluminum look.

www.rvinyl.com

Cant wait to see some pics

Those look pretty sweet, just worried if they are cut to exact fit, slightly off center can turn into a nightmare on longer runs

 

[Big Papa Gecko]

So passenger front door done, big wreck in town so was slow getting home. Will do last 2 doors tomorrow and start pulling dash apart. Better picture this time atleast.

 

[CoronaRaptor]

Yes, looks a lot better in the daytime. So, does this stuff have glue on it already? Do you heat it up with a heat gun? C'mon bro, I want more info, this is something I've been wanting to do.

 

[Big Papa Gecko]

Yes, looks a lot better in the daytime. So, does this stuff have glue on it already? Do you heat it up with a heat gun? C'mon bro, I want more info, this is something I've been wanting to do.

So with the 3M 1080 and 2080 its pressure adhesive on the back, haven't had to use the heat gun yet but expect i will for the tighter bends on the bezel and such. I use isopropyl alcohol and clean them prior to putting the adhesion promoter around the edges, holds better with it. Then put the vinyl, got a nifty tool kit on Amazon with the squeegee type things and an exact blade.

 

[CoronaRaptor]

So with the 3M 1080 and 2080 its pressure adhesive on the back, haven't had to use the heat gun yet but expect i will for the tighter bends on the bezel and such. I use isopropyl alcohol and clean them prior to putting the adhesion promoter around the edges, holds better with it. Then put the vinyl, got a nifty tool kit on Amazon with the squeegee type things and an exact blade.

Okay, cool, yeah, will probably need a heat gun on the corners. Keep up the good work bro!