2024 Raptor | Baja Designs LP4 | SDHQ | SPV

[mleaky]

Installed some Baja Designs LP4's.

-SDHQ A Pillar Ditch Light Brackets
-Baja Designs LP4's, amber backlight
-SPV A Pillar harness. Ran the harness under the cowl and in between the fender where it mounts, towards the A pillar.
-SPV running light harness
-ARP 12pt Bolts and Nuts. The plan was to lockwire the bolts, but I broke the only 1/16 bit I had.
-Used some left over Gray Techflex and Shrink tubing from a KTM wiring project
-4 way zip tie mounts and zip ties. Mounts are under the cowl.

Running light harness routing under the plastic cover


Laying out the A pillar light harness location






Prettied up the light harness a bit


LP4's with ARP Hardware(Orange Locktite)




Final Product. Just need to adjust the lights a bit more and buy the LP4 side reflector covers

 

[TXchris]

Looks good! I'm very indecisive on the XL80's or LP4's. Then I have to figure out if I want Clear or Amber... LP4's look good on your truck.
Thanks for sharing.

 

[Baja Designs]

Looks good! I'm very indecisive on the XL80's or LP4's. Then I have to figure out if I want Clear or Amber... LP4's look good on your truck.
Thanks for sharing.

Hope our XL 80 vs Lp4 blog can help out. It just comes down to what you may be looking for. XL 80 will provide slightly more lumens, but the Lp4 comes with Integrated Peripheral Technology (IPT) which gives a 200-degree spread and a backlight. As for the lens, the great part about our lighting is the possibility of swapping out the lens to a different color or pattern without voiding the lifetime warranty.

Best,

Brahian Herrera | Forum Sales & Support
Email: [email protected] | Phone: (760) 560-2252 Ext 201

 

[MDJAK]

Installed some Baja Designs LP4's.

-SDHQ A Pillar Ditch Light Brackets
-Baja Designs LP4's, amber backlight
-SPV A Pillar harness. Ran the harness under the cowl and in between the fender where it mounts, towards the A pillar.
-SPV running light harness
-ARP 12pt Bolts and Nuts. The plan was to lockwire the bolts, but I broke the only 1/16 bit I had.
-Used some left over Gray Techflex and Shrink tubing from a KTM wiring project
-4 way zip tie mounts and zip ties. Mounts are under the cowl.

Running light harness routing under the plastic cover
View attachment 482279

Laying out the A pillar light harness location
View attachment 482280
View attachment 482281
View attachment 482282
View attachment 482283
View attachment 482284

Prettied up the light harness a bit
View attachment 482285

LP4's with ARP Hardware(Orange Locktite)
View attachment 482286
View attachment 482287
View attachment 482288

Final Product. Just need to adjust the lights a bit more and buy the LP4 side reflector covers
View attachment 482289

looks great. I have the same lights in the same place. May want to get the blinders on the inside. BTW, exactly which bolts are those holding the lights to the brackets? Security bolts?