X liner in rear wheel wells

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

2baddogs

Full Access Member
Joined
Feb 14, 2011
Posts
193
Reaction score
101
Location
Las Vegas
Got tired of seeing paint over spray so I had it blacked out. Looks better and less sloppy.

Looks good! Funny just called 4theTruck yest to make an appt on 25th. Where did you get yours done? How much? Pm me if you prefer.

Thanks
Pat
 
OP
OP
Vegas Raptor

Vegas Raptor

Full Access Member
Joined
Nov 5, 2013
Posts
127
Reaction score
85
Location
Las Vegas NV
Sorry for late reply...I had the X liner job done at 4 the truck as well. The did a couple jobs...total $345...As for the job itself I think it was $180...
 

mprice1234

SVT Gen 1 Rules
Joined
Oct 26, 2010
Posts
5,074
Reaction score
10,502
Location
Colorado Springs, CO
One of the best mods

I did this four years ago and is by far one of the best mods I've done. Looks as good as the day they sprayed it and makes the truck look so much better.
 

Attachments

  • 100_0088.jpg
    100_0088.jpg
    118.7 KB · Views: 147
OP
OP
Vegas Raptor

Vegas Raptor

Full Access Member
Joined
Nov 5, 2013
Posts
127
Reaction score
85
Location
Las Vegas NV
Excellent work

The boys at 4 the truck do a real bang up job. A lot of attention to detail...notice in pic that they sprayed the support rods too.
 

Attachments

  • 20150911_164854.jpg
    20150911_164854.jpg
    99.9 KB · Views: 181

AggieSVT

Full Access Member
Joined
Oct 24, 2013
Posts
112
Reaction score
32
Location
Killeen, TX
I did the same thing and I've had mine for about 1 1/2 years. No chips yet. I did it myself though, with a little elbow grease and two cans of spray on bed liner.
 

dcheshire

Member
Joined
Aug 28, 2015
Posts
7
Reaction score
1
Location
Philadelphia Suburbs
Can anyone tell me if they remove the fender flares when they spray the wheel wells? I am going to do this myself hopefully tomorrow. I'm assuming they should stay in place so they continue to fit tight to the wheel well.

Also, I plan to use a wire brush to rough it up in lieu of sand paper. Good idea or not??

Thanks for any advice.
 

SonnyAK

Full Access Member
Joined
Mar 22, 2013
Posts
443
Reaction score
429
Location
Anchorage, AK
They didn't remove anything on mine, but they did do a great job taping everything off. My Linex guy used a different material underneath for my wheel wells - it's a bit thinner spay material than the regular line - more of an undercoating product.
 
Top