What did you do to your Raptor today? (Gen2)

[badm0t0rfinger]

View attachment 427697picked this is up from the junkyard today.. just gonna swap my internals into it and roll

Put a new cover on it while you're at it

 

[JohnyPython]

Maybe the next oil change will be a little easier/less messy. FUMOTO F107SXView attachment 427683

Yes, it’s a breeze with the Fumoto valve. Oil goes right into an empty jug.

 

[downforce137]

Put a new cover on it while you're at it

For sure.. not sure which one I'm going to do. I think the nodular iron one is probably stronger but the aluminum one is lighter.. not sure which I'm gonna go with but I am reluctant to add weight because I know of a couple trucks with mounts that broke off when jumping..

 

[XSTNKT]

Maybe the next oil change will be a little easier/less messy. FUMOTO F107SXView attachment 427683

I was wondering if the adjustible version would fit (or if it was even needed). Thanks for posting this!

 

[Sig Fanboy]

I assembled my Overlanding rack, still waiting on brackets to attach it to the bed. Trying to determine if the reg Rotopax mounts will attach to my accessory panels. Trying to keep my stuff to the inside of the panels for tights trail but the Rotopax will have to go on the outside. Will have to cut the top section of my Builtright bed panels.I lost a ton of weight by ditching the factory bumper, tail pipes and spare tire winch and now adding the weight back!!! Any insight from any Rotopax experts on here would be appreciated.

 

[Sig Fanboy]

View attachment 427697picked this is up from the junkyard today.. just gonna swap my internals into it and roll

Nice junk yard score. All I ever seem to get from the salvage yard is more junk.

 

[Bozz]

I assembled my Overlanding rack, still waiting on brackets to attach it to the bed. Trying to determine if the reg Rotopax mounts will attach to my accessory panels. Trying to keep my stuff to the inside of the panels for tights trail but the Rotopax will have to go on the outside. Will have to cut the top section of my Builtright bed panels.I lost a ton of weight by ditching the factory bumper, tail pipes and spare tire winch and now adding the weight back!!! Any insight from any Rotopax experts on here would be appreciated.

Probably going to have to cut the tops of my Builtright bed panels to attach my Billiebars. Trying to figure out how to avoid that.

 

[debauch]

I learned about Forscan recently. I just finished the reverse tilt mirrors and global window open/close tweaks. Pretty handy.

 

[Sig Fanboy]

Probably going to have to cut the tops of my Builtright bed panels to attach my Billiebars. Trying to figure out how to avoid that.

For what’s it’s worth, I cut the top section off with a Milwaukee vibratory cutter with a titanium blade while they were still mounted to the truck. I put some black touch up paint on the cuts. I have the mounting bracket for my CO 2 tank on drivers side panel. Intend to put a Rotopax water container on the passenger side. Kinda sucked to cut them up but had to do it

 

[grleon65]

Got my poor boy exhaust sorted and my ADD bumper on. Gotta work up the courage for dove tailing the bed. Any suggestions on a good tail gate net?

I got one of these for the interior of my raptor to tie misc stuff down (coolers, chairs, camera bags, etc). It's a bit large, so I need to cut it down some - there are different sizes available that may make a reasonable custom tailgate.





https://www.vevor.com/cargo-net-c_1...7-gKLDP8_0SSI9BaE3gWFNE-325vuguVpU_E2jGZZ7EBg