What did you do to your Raptor today? (Gen2)

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

91Eunos

Full Access Member
Joined
Oct 18, 2018
Posts
876
Reaction score
1,681
Location
Hill country, Tejas
XL80s (along with the other lights) have shipped, but not here yet... Went ahead and installed the SDHQ brackets:

i-dLrK4C4-X3.jpg

i-ppPZBwX-X3.jpg

These things are money baby...very solid mount!

Pro tip: remove the masking tape before snugging everything down... DAMHIK. :rolleyes:

Also, the rubber trim around the cowl cover halves WILL fit around the mounts without trimming...just be patient, and work it around the bracket.

Also, another unplanned bit of maintenance as I was finishing up...dropped a wrench down inside the fender. So I got to partially remove my fender flares and pop out the bottom of the fender liner to get to the wrench. Bonus was that I got to clear out all the leaves and debris that accumulates there; something I typically do once a year on all my cars anyway.

Went ahead and cleaned out both sides... So the dropped wrench was a bit of inadvertant excellence I suppose!
 
Last edited:

_Satch_

Member
Joined
Nov 14, 2018
Posts
21
Reaction score
9
Location
Montoursville PA
Changed the break-in oil and filter. Replaced the drain plug with the Fumoto valve with the 3/8 nipple so the next oil change should be easier.
-Satch
 
Top