What did u do to your raptor today?

[RLTW]

This is in and the rear bypasses are rebuilt so the truck isn't depressing to drive anymore.

 

[yoopercharged]

Meanwhile I'm over here celebrating that my Geisers showed up last night. One step closer to getting this setup installed!

 

[Jakenbake]

This is in and the rear bypasses are rebuilt so the truck isn't depressing to drive anymore.

View attachment 371809

What is your plans for the windshield washer bottle?

 

[RLTW]

What is your plans for the windshield washer bottle?

i'd already broken the tabs holding it up at some point previously, it was just being held in place by my previous liners, I drilled a couple holes in the battery box and moved the entire thing up as far as it could go. If I still happen to notice clearance issues then evil makes a metal low profile "bottle"

 

[Jakenbake]

i'd already broken the tabs holding it up at some point previously, it was just being held in place by my previous liners, I drilled a couple holes in the battery box and moved the entire thing up as far as it could go. If I still happen to notice clearance issues then evil makes a metal low profile "bottle"

Evil bottle is a bit pricey. I think I’m removing mine and going to a small round bottle up behind the grill. Not sure yet.

Mine wasn’t leaking until my wife pulled a strip of rubber off of it exposing a nice crack in the tank, lol

 

[taybraith]

Decided to pull the hoses through this seam as that was the only place I could locate them. Thanks to everyone for the guidance. Glad to finally have this one done.

View attachment 371420View attachment 371421

What is this for?

 

[RLTW]

Evil bottle is a bit pricey. I think I’m removing mine and going to a small round bottle up behind the grill. Not sure yet.

Mine wasn’t leaking until my wife pulled a strip of rubber off of it exposing a nice crack in the tank, lol

after the cost of other suspension components i'm pretty unphased by the wiper tank but I can always appreciate a diy project.

 

[Jakenbake]

after the cost of other suspension components i'm pretty unphased by the wiper tank but I can always appreciate a diy project.

Yea, I understand that pretty well………

I still need to figure out the intake as I’m not really running any fender liners any more. I have started building sections of them, but I am still chewing on how to protect but not block the air box.

 

[RLTW]

Yea, I understand that pretty well………

I still need to figure out the intake as I’m not really running any fender liners any more. I have started building sections of them, but I am still chewing on how to protect but not block the air box.

I've had a ump canister in there for about 6 or 7 years that has done a solid job, its not gaining me any power but I'm not concerned about it getting me in trouble either.

 

[Jakenbake]

I've had a ump canister in there for about 6 or 7 years that has done a solid job, its not gaining me any power but I'm not concerned about it getting me in trouble either.

Nice, I have been thinking about one as well. Which filter, Donaldson?

Are you able to remove the filter without removing the housing?