What did u do to your raptor today?

[Deleted member 12951]

Just about tore the drivers side mirror off at a "Touchless" car wash. I was a bit off center and forgot to retract the mirrors. Then came home and used Adams rust remover on the hood. Had more contamination they I thought. Then had to re-polish the hood.

Take a gander at the Raptor supplemental manual, page 25

http://www.fordservicecontent.com/F...ement-First-Print_rp_en-us_09_2013.pdf#page27

 

[Buzzard2]

It was a touchless car wash, I just started playing on my phone and forgot about the mirrors. Been thru this car wash many times with no issues. Just plain old operator error!!

 

[pat247]

Drove to New Braunfels, TX yesterday to drop it off at Comal Truck Gear at @treypal place to fix some TRR aftermath, rebuild all the shocks and get it ready for the Pony Express and Wyoming Trail run. Flying home today and flying back in two weeks to pick it up.



Texas and their mandatory face mask order that was put in place yesterday. Thankfully this convenience store gave me a free one.

Small world, I to drove to San Antonio and back over the past two days. I bet our paths crossed somewhere along the way.

 

[ogdobber]

View attachment 147078 View attachment 147078
Nice Lug nuts, way better than my factory ones. I would like to get some good stainless ones but cant seem to find a good source.

I got nicecnc from eBay. Thought it said “made in USA” but in reality it was “USA stock” lol nice quality tho. However they are a smaller diameter seat like what methods use. I’m not sure if you are supposed to use the small seat on the stock rims


Sent from my iPhone using Tapatalk Pro

 

[Frogger22]

You need to clean that gauge cluster first

 

[98rangerdave]

Finally got around to painting my rear bumper. Used 200 grit sandpaper to get the surface rust off and used painters paper to mask everything off. Bought 2 cans of Steel It but only used one and this job. I’m looking for something else to Steel It now, this stuff was expensive and don’t want it do to waste.

 

[bruiser]

Finally got around to painting my rear bumper. Used 200 grit sandpaper to get the surface rust off and used painters paper to mask everything off. Bought 2 cans of Steel It but only used one and this job. I’m looking for something else to Steel It now, this stuff was expensive and don’t want it do to waste.

View attachment 147148

nice have anymore pics?

I'd like to build my own as well

 

[Rustyj41]

Installed geiser springs on mid perch. Also swapped for a set of freshly rebuilt front shocks from forged. Opted for vitron seals and flutter stacks. Impressed by the ride quality. My front right was completely dead.

Just found out I need a new CV on the passenger side. So next will be that with either a IWE rebuild or delete.

 

[98rangerdave]

nice have anymore pics?

I'd like to build my own as well

Here’s a few more angles, 1 3/4” tube and a weld in receiver braced in multiple points.

 

[Jakenbake]

Not today, but recent. I cut up a perfectly good builtright bedside panel to get some clearance around my air compressor.