What did u do to your raptor today?

[JtoU]

Yo. Truck is still looking good. How you been?

Truck could be lot better if Fox would send me warranty parts to fix my new shocks. Hopefully it's ready on time for Morocco trip. Working my ass off to pay truck parts Honestly been pretty busy with work, school and family, there is not enough hours in day to do anything else. How about you?

 

[sj-CHI]

Cleaned up and tweaked some wiring:
- Changed from Sho-Me flasher modules to Rigid high output versions
- Added diodes to safeguard the modules during steady burn
- Added A-series Rigids to the bed

Sent from my iPad using Tapatalk

 

[JtoU]

Started front suspension install and got most of done. Still missing warranty parts for left side so can't finish that side yet. Broke also Icon upper while trying to remove uniball, it was very corroded and housing cracked. I had to put stock ones till i get new Camburg kinetik uppers.

For those that are going to install this kit to Camburg upright, be prepared to grind shit ton to get it working. Definitely not bolt-on kit to Camburg upright but can be made to work since you need to grind from places that are very thick.

 

[2014RubyRed]

Truck could be lot better if Fox would send me warranty parts to fix my new shocks. Hopefully it's ready on time for Morocco trip. Working my ass off to pay truck parts Honestly been pretty busy with work, school and family, there is not enough hours in day to do anything else. How about you?

Doing good. Busy at work as well. Enjoying our cooler weather.

Good luck with your parts. Hope you make the next run!

 

[ogdobber]

Is that a reflective tape covering the entire license plate? I would love this to avoid getting caught in between a red light cam.


Sent from my iPhone using Tapatalk

Nah that's just Photoshop. I did look up reflective spray after I read this and it seems it doesn't really work


Sent from my iPhone using Tapatalk Pro

 

[wakko0o]

Nah that's just Photoshop. I did look up reflective spray after I read this and it seems it doesn't really work


Sent from my iPhone using Tapatalk Pro

Yea I would also think the spray would wash off also. But tape might work. I seen a UK clip where a guy molded his letters and numbers on the plate and got a reflective tape on it. Looked original and when he flashed a pic with his camera numbers & letters gone!


Sent from my iPhone using Tapatalk

 

[SZDZMTR]

Ordered a Tuffy under seat storage box. Tired of shit flying all over ...
Shipped the 40 inch E Series bar that I picked up used here on the forum back to Rigid for a small overhaul. Very easy process with their warranty department. Had slight condensation in the driver side corner, broke a bolt when tightening to the tab, the shell looked kind of shabby. Amazingly it is not costing me a dime except shipping cost, fantastic customer service.

 

[Bulletnjm]

Started front suspension install and got most of done. Still missing warranty parts for left side so can't finish that side yet. Broke also Icon upper while trying to remove uniball, it was very corroded that housing cracked. I had to put stock ones till i get new Camburg kinetik uppers.

For those that are going to install this kit to Camburg upright, be prepared to grind shit ton to get it working. Definitely not bolt on but can be made to work since you need to grind from places that are very thick.

Is that the BOLT kit?

 

[t_j]

Wired up my new Viking horns, then promptly set the alarm off slamming to hood. ******** they are loud!


Sent from my iPad using Tapatalk

 

[HellfiendTX]

Did the backseat mod on the Drivers side.