What did u do to your raptor today?

[mprice1234]

Found this today after an oil change from the filter drain.

Feel better about buying an extended warranty now.

Any guesses what this could be. Going to get a magnet soon to rule things out.

Magnet test will help to determine what it is or what its not. Wondering if it was just some sand or dirt on the filter drain pan?

 

[Evpilot]

Washed and polished the Paint Before putting on car pro cquartz. Used cerakote on the plastics.

 

[ShadyRaptor]

Installed the factory exhaust back

 

[ShadyRaptor]

Installed Ford Performance Parts rear diff cover
View attachment 167492

and R1 Concepts Brake discs & pads
View attachment 167493

How do you like these brakes compared to OEM?

 

[BlueOvalF22]

OK so I need to flip the pintle plate to lift it but the SVC rear bumper wont need to run the big drop plate upside down like a regular F150 receive would need to do.

Next, I need to wire up a 7 pin in place of the NATO plug.

Then I need to remove all the air side of the air brakes including the master and then plumb and wire in electric over hydro and a break away kit.

 

[B E N]

Reinforced spindles, all new bushings, ball joints, UCA, alignment kit, tie rods, end links, both sides. Drives nice ~ Every single part was loose enough to warrant replacement. Drive hard, maintain hard

 

[BlueOvalF22]

Hi Lift will go in the trailer, only big wheel in the truck.

 

[Chiefapple]

View attachment 168999Washed and polished the Paint Before putting on car pro cquartz. Used cerakote on the plastics.

Its amazing what washing a truck can do nowadays! Turned a Gen1 into a Gen2!

 

[Chiefapple]

Small send on a jump you could only get to about 50 on.

 

[Chiefapple]