What did u do to your raptor today?

[BlueGoliath96]

Removed +2 fiberglass from ADV went with their 4.5 .






Sent from my iPhone using Tapatalk

 

[Gary E]

He plastidipped them. Like he said in the post.

What a response. A bit harsh, but whatever. Plastidip: a rubber coating. Interesting.

 

[badm0t0rfinger]

It can be peeled off, unlike paint!

Unless you put on your cars hood and leave it out in an open parking lot during an entire 10 month deployment allowing it to cook every day...

AS AN EXAMPLE...

 

[RC51TOFUMAN]

Purchased this extra set..in 2016
Going to drop them off at Fox Service Center in the morning to have them rebuilt/serviced


Sent from my SM-G973U using Tapatalk

 

[GWBush]

Drove to pick up breakfast and took a pic. Cuz shiny.

 

[BlueGoliath96]

Hey there guys !

Do you fellas know if there is any aftermarket brands that sell upgraded Wheel bearings for the Gen 1s ?


Thanks in advance


Sent from my iPhone using Tapatalk

 

[MEIRONMAN207]

Another final ending in my series of posts in the post-COVID repair/replacement segments. Everything went smoothly and no runs, no drips and no errors. (Except for a minor hiccup due to the wrong u joints listed incorrectly at the parts stores). Report; while I had no driveline wobble or vibrations other than the slight early seal leak, I did have a slight bump/clunk on takeoffs. The slip yoke shaft was indeed a bit dry. After the u joints replacement and seal, I also lubed the shaft. Went for a highway run and a noticeable improvement! Everything feels nice and tight again and no bump, wobbles or vibrations to report. (Once again care was taken in the description due to potential views from minors). Also, included in the final/after pics are the parts used and correct numbers...

 

[MEIRONMAN207]

More pics;

 

[ogdobber]

Went and had breakfast at one of my favourite places in the Malibu canyons (Old Place) and a trx parked next to me. First time seeing one in person. Nice, but I prefer my Raptor



Sent from my iPhone using Tapatalk Pro

 

[badm0t0rfinger]

I've always been under the impression that the slip yoke has to basically be covered in grease before install. I've pulled it once and threw some red n tacky on it and cleaned off the bit that squeezed out.