Updating 35 to 37 on Forscan

[TurboD97]

Hi All:
I just bought a set of factory spec 37s for my 35 truck. I'm trying to find the right code to reset the speedo in Forscan. Would anyone with a 37 truck care to share what their truck shows in the following sections:

BCM line 726-15-01
BCM line 726-15-02

Thanks!

 

[Zach Gen3]

Hi All:
I just bought a set of factory spec 37s for my 35 truck. I'm trying to find the right code to reset the speedo in Forscan. Would anyone with a 37 truck care to share what their truck shows in the following sections:

BCM line 726-15-01
BCM line 726-15-02

Thanks!

I am planning to do this update tonight, any chance you figured it out?

 

[Littlefx4]

Hey fellas. Open the below link and read post 219 & 230. Hope this helps.

GEN3 Forscan

I notice it was removed. Not sure why. The Quiet time mode in the apim is FoE Seatbelt Warning Strategy (FESWS) • Quiet Time Exhaust Mode (QTEM) • Clear Exit Assist (CEA) 7D0-09-05 xxxx-xXxx-xx-- 0 = FESWS Disabled • QTEM Disabled • CEA Disabled 8 = FESWS Enabled • QTEM Disabled • CEA...

www.fordraptorforum.com

 

[DAF]

Hey fellas. Open the below link and read post 219 & 230. Hope this helps.

GEN3 Forscan

I notice it was removed. Not sure why. The Quiet time mode in the apim is FoE Seatbelt Warning Strategy (FESWS) • Quiet Time Exhaust Mode (QTEM) • Clear Exit Assist (CEA) 7D0-09-05 xxxx-xXxx-xx-- 0 = FESWS Disabled • QTEM Disabled • CEA Disabled 8 = FESWS Enabled • QTEM Disabled • CEA...

www.fordraptorforum.com

Yup just did it this way a few days ago, worked perfect. Confused why some people were talking about entering tire circumference when you can just do it this way.

 

[Chuckaroo91]

Yup just did it this way a few days ago, worked perfect. Confused why some people were talking about entering tire circumference when you can just do it this way.

Bumping an old thread, but did you need to do anything to reset the PCM / TCM?

 

[DAF]

Bumping an old thread, but did you need to do anything to reset the PCM / TCM?

Yea I reset both if remember correctly. Really easy to do