On board air compressor?

[sj-CHI]

Here is an install I finished up a few weeks ago. Second truck I have setup with onboard air — definitely worth it. The ARB compressor doesn’t disappoint and check Swarfworks for the air tank frame mount. Paul’s products are top notch.

 

[Cody Templeton]

Here is an install I finished up a few weeks ago. Second truck I have setup with onboard air — definitely worth it. The ARB compressor doesn’t disappoint and check Swarfworks for the air tank frame mount. Paul’s products are top notch.

View attachment 321460View attachment 321461View attachment 321462View attachment 321463View attachment 321464

That's a very nice setup! Super clean!

 

[TheCzar]

DIRECT FIT TRAIN HORN AND ONBOARD AIR SYSTEMS FOR 2017-2024 FORD F-150 RAPTOR SUPERCREW

Equip your Ford Raptor SuperCrew (2017-2024) with Kleinn's Direct Fit Train Horn and Onboard Air System. Engineered for off-road dominance and superior sound.

kleinn.com

I did this minus the horns. compressor and tank mounted to the frame on passenger side. On/Off controlled by Aux6. And I ran the air hose into the bed and mounted it to my bedside rack by the tailgate

 

[Darthyota]

I mounted mine behind the rear passenger seat

 

[Darthyota]

 

[RussS]

Most of the Raptor guys here in Dubai run the on-board twin piston ARB and mount in a frame underneath the Passenger side rear seat. The ARB is quick and not loud (although not sure why that would matter too much).
I typically inflate from 10PSI to 38PSI in around 6/7 minutes. I also have a ‘4 in 1’ hose system so all tyres inflate at the same time, saves a lot of hassle especially when its 40 degrees C + outside.

 

[Cody Templeton]

I mounted mine behind the rear passenger seatView attachment 321612

Looks clean, but I wanna put my inverter there. lol

 

[Cody Templeton]

Most of the Raptor guys here in Dubai run the on-board twin piston ARB and mount in a frame underneath the Passenger side rear seat. The ARB is quick and not loud (although not sure why that would matter too much).
I typically inflate from 10PSI to 38PSI in around 6/7 minutes. I also have a ‘4 in 1’ hose system so all tyres inflate at the same time, saves a lot of hassle especially when its 40 degrees C + outside.

It's been a tough decision between the ARB twin setup or the two Viair compressors. All I know is whatever I use it'll get mounted somewhere near the spare tire area.

 

[Darthyota]

Looks clean, but I wanna put my inverter there. lol

Depending on the size of the inverter you could still get one there with the compressor there. That or swap the one out from u der the center console

 

[Cody Templeton]

Depending on the size of the inverter you could still get one there with the compressor there. That or swap the one out from u der the center console

I'll be running a pretty hefty sized one.