25% seems high to me, at least based on what I've personally seen on Dynos. I've typically seen 18-20% driveline losses through torque converted trannys
auto cars sure closer to that range, trucks more like 20-25%, lowest would be a sportbike ;-)
Forget about all that though - LOOK AT THE REAR WHEEL TQ figures!!!!!!!!!!!!!!!!!!
Right below the HO 3.5 F150 #'s are the 87 vs 93 #'s on a charger rated @ 395 TQ @ the crank, they say on 87 its still pushing 364 lb/ft to the wheels vs. 395 @ the motor - less than 8% loss? I don't think so.
Something is off about these dyno results, the HP #'s are definitely believable/reasonable, but the TQ figures make no sense. Maybe they used a hub dyno & that's the reason for the extremely high TQ figures???
On 1 hand using a hub type dyno is a little misleading b/c most people are more familiar w/ a chassis-type, but on the other hand hub dynos read way more accurately & for the purposes of their test would be a better tool since their concern is really the immediate before/after effects of low vs higher octane on the same vehicle.
Now that I think about it, probably the case - anyone w/ a copy of the mag can, does it say what type of dyno they used to test the cars?