I've Owned my Raptor for 2 Months, It's been at the dealer for Most of it

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

EricM

FRF Addict
Joined
May 11, 2016
Posts
3,463
Reaction score
3,173
Location
OHIO
Are they anywehre near each other? You can get some foil based wire wrap/insulation and shield it to make sure.
 

FordTechOne

FRF Supporting Member
Supporting Member
Joined
Jul 29, 2019
Posts
6,657
Reaction score
13,029
Location
Detroit
So update guys, I just got my NEW engine andddddd BAM. Low PRESSURE WARNING!!!!!

What is going on ???

I have a little theory that it going through my head and would like to see what y'all think.

Whenever I drive I like to flip my third aux switch and put on my LED foglights (as seen in my picture). When the dealership test drives my truck thoroughly, they do not do this and the issue never happens for them. As soon as I drive off the lot with this switch on, I get the issue in about 10-20 min. Could it be a faulty wiring situation??
Sounds like someone installed the lights/harness too close to the PCM or its harness. That can induce electromagnetic interference which skews sensor readings, especially those on VREF.
 

letsgetthisdone

Full Access Member
Joined
Mar 13, 2019
Posts
462
Reaction score
440
Location
Las Vegas, NV
Sounds like someone installed the lights/harness too close to the PCM or its harness. That can induce electromagnetic interference which skews sensor readings, especially those on VREF.

There is not that much current in an LED aux light kit to mess with VREF sensor. It could *maybe* effect a hall effect sensor, or unshielded can bus. But those are generally run in twisted pair to prevent interference.
 
Top