Interior Raptor Emblem Install Question

[RatedSVT]

Well where ever you put it post some pics =)

 

[Mavrik]

Dash Mounted Raptor Emblem

OK so I finally decided to break out the belt sander, the Dremel tool, an Xacto knife and some double sided tape and start a little mod work on a tailgate emblem for the dash area under the passenger airbag. I kinda thought the interior could use a little Raptor propaganda and so this is what I ended up with. Had to nix the "SVT" part because it just hung too low but the Dremel shaped it up nicely. Oh and sorry for the crappy pics. A photographer I am not.

 

[Maxx2893]

Looks good man!

 

[TheJEPs]

Very nice, and looks like it fits perfectly!

 

[RatedSVT]

Looks good Mavrik, how do you like it?

 

[BOJANGLES]

I remember the guy who mounted his on the airbag.... That was amongst the greatest Raptor fails in the history of Raptors.
If you've ever removed one of these emblems, then you know that the points of the R's are sharp enough to puncture skin without the force of an airbag behind it.

I for one removed my Raptor and F-150 emblems, ditched the F-150 emblem and relocated the Raptor emblem to the left side of the tailgate covering the alignment holes previously used by the F-150 logo. 3M double-sided tape is crazy-strong when used properly.

 

[Maxx2893]

I remember the guy who mounted his on the airbag.... That was amongst the greatest Raptor fails in the history of Raptors.
If you've ever removed one of these emblems, then you know that the points of the R's are sharp enough to puncture skin without the force of an airbag behind it.

I for one removed my Raptor and F-150 emblems, ditched the F-150 emblem and relocated the Raptor emblem to the left side of the tailgate covering the alignment holes previously used by the F-150 logo. 3M double-sided tape is crazy-strong when used properly.

I remember that on the other place.

 

[Mavrik]

It actually came out pretty nice...Better than I thought it would to be honest...The 3D look adds a nice touch inside and Bojangles is right, that 3M outdoor double sided tape is no joke...I appreciate the compliments folks...Peace

 

[TheJEPs]

I for one removed my Raptor and F-150 emblems, ditched the F-150 emblem and relocated the Raptor emblem to the left side of the tailgate covering the alignment holes previously used by the F-150 logo. 3M double-sided tape is crazy-strong when used properly.

I was hoping to do the same thing, do you have a picture or two you can put up to show how it turned out? Did it completely cover all four holes?