ICON 3.0 Coilover, Upper Control Arm + Skid Plate installation write up

[iSurvive]

Firestone Service Center. Me and another FRF member got them done at the same time. $159 was the deal we cut with the service manager.

 

[Deleted member 12951]

So I go and measure the height from the center hub cap to the bottom of fender.
Driver side: 25"
Passenger side: 25.5"

And I had a well known raptor shop install these.

 

[WRCRaptor]

I would not use the hub to fender measurement myself since there are variations in body panels. Others may disagree. I would use things like sub frame or frame to ground points. To really get a good set up use scales like a race car to comer weight the suspension/chassis, drivability and handling performance will be better when properly corner weighted. On my race/rally cars once they were corner weighted I could measure fender to hub and they were never equal side to side. The cars looked normal not off side to side. Someday when I get adjustable coil overs the scales will get a workout since the Raptor is a lot heavier then then my old VW golf rally car!

 

[39Mustang]

How do their shocks compare to the Fox and Kings?

 

[Deleted member 12951]

 

[ntm]

How do their shocks compare to the Fox and Kings?

Lots of info here:
Guys with icons ? - FORD RAPTOR FORUM - Ford SVT Raptor Forums - Ford Raptor

 

[KaiserM715]

How do their shocks compare to the Fox and Kings?

There are several threads covering this in this section, please discuss that comparison there rather than in this thread.

 

[39Mustang]

There are several threads covering this in this section, please discuss that comparison there rather than in this thread.

I have no idea and still fairly new to forum, hence why I asked

 

[Wilson]

He comes across as a turf are but he's ok

 

[Madcowranch]

A turf?