Glove box separating

[smgilles]

Anyone have an issue with the glove box separating from the dash?




Sent from my iPhone using Tapatalk

My 2017 looked the exact same. I tore it apart and realigned everything and still had annoying gap, so I put sticky velcro along the inside that pulls it up tight when shut.

 

[2020Raptor]

On the side that is staying open, there is a rubber bumper.
I do not recall if it is on the door or the box.
Remove it and the door will close normally.
I do not know why it is there, unless for assembly or shipping purposes.

 

[BOS1600]

On the side that is staying open, there is a rubber bumper.
I do not recall if it is on the door or the box.
Remove it and the door will close normally.
I do not know why it is there, unless for assembly or shipping purposes.

I’ll check... but this just started out of nowhere


Sent from my iPhone using Tapatalk

 

[2020Raptor]

Interesting.
Mine was like this on day 1.

 

[dixonk]

Mine is doing the same thing. Dealer checked it out and ordered me a new glove box.

 

[2020Raptor]

This is odd.
Check and see if you have that bumper on the left side of the door/box.

 

[mattrofact]

Had the same issue and the glove box was removed and reinstalled properly under warranty. Also had an issue where the door card armrest leather lost its texture and that was also replaced under warranty.

 

[Ducc]

Same issue with my '20 and glad to see dealerships are taking care of it.

 

[ChrisK661]

Mine came with a small gap but between the fluted item and the wall not the box door. Does it close? warranty item. That sucks

 

[raptor ghost]

My 2017 looked the exact same. I tore it apart and realigned everything and still had annoying gap, so I put sticky velcro along the inside that pulls it up tight when shut.

^Had the same exact issue after I switched out the cabin air filter and it drove me nuts. Slightly a bit ocd so I took a couple hours to figure it out that I put it back together wrong

If you do not engage that one clip at the bottom most left corner of the cabin air filter cover (see 9:11 in the youtube clip). Even if you tighten down the two bolts without getting the leftmost clip engaged you'll still have a gap as pictured above. you may have to slightly flex the edges/taco them towards you and firmly push it into place until it latches

also possible the clips were broken at some point, but more likely it wasnt snapped back in place firmly enough