Gen 3 Raptor 4A increased vibration when accelerating

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

rockstarr22

Member
Joined
Nov 10, 2021
Posts
4
Reaction score
0
Location
West Palm Beach, FL
Just upgraded to gen3 from gen2. Never felt it in gen2, 2019.

Gas pedal vibration @54-56 mph at steady load. If you let off gas or begin accelerating vibration sometimes goes away or gets a little worse. Again, never an issue in my gen2
 

New recaros

FRF Addict
Joined
May 23, 2019
Posts
2,895
Reaction score
4,578
Location
Colorado
Just upgraded to gen3 from gen2. Never felt it in gen2, 2019.

Gas pedal vibration @54-56 mph at steady load. If you let off gas or begin accelerating vibration sometimes goes away or gets a little worse. Again, never an issue in my gen2
I had a limited that did that at 52 mph. I also had a small bit of vibration in the steering. They rebuilt the transfer case, no fix, the redid the hubs no fix, they found a broken gear in the front differential. All that after three wheel balancing and rotations. It would go away in 4A.
 

laramie1pt8t

Active Member
Joined
Jul 28, 2022
Posts
51
Reaction score
17
Location
NH
I too have a vibration in 2H, I am going try 4A/H and see if it gets worse. If I stomp the pedal from a stop or rolling I get a few shakes and then it goes away. Almost feels like the rear end or driveshaft.
 

rockstarr22

Member
Joined
Nov 10, 2021
Posts
4
Reaction score
0
Location
West Palm Beach, FL
I too have a vibration in 2H, I am going try 4A/H and see if it gets worse. If I stomp the pedal from a stop or rolling I get a few shakes and then it goes away. Almost feels like the rear end or driveshaft.

I’m good in 2H, it’s when I’m in 4A that I’ve noticed it.

I just realized I haven’t tried it in 4H.

Will report back once I do.
 
OP
OP
awd5906

awd5906

Active Member
Joined
Mar 10, 2022
Posts
78
Reaction score
54
Location
NY
Just to follow up, try moving your pedals all the way ‘forward’ to the furthest position. Closest to the firewall. I’ve noticed the vibrations drop quite a bit when the pedals are as close to the firewall as they will go.
 
Top