Gap in bed

[PSU_Fred]

So...I'm out this past Saturday at the dunes having a blast...doing what this thing was meant to do! My buddy takes his Power Wagon and we play "Anything you can do, I can do better."
I get back and get to detailing it Sunday, when I notice a small separation between the floor of the bed and the front wall. It's about 1/8" wide separation.
Anyone ever seen it?
I'm taking it to the dealer tomorrow.

 

[DANACO]

Supposed to be that way, allows water to drain.

 

[RaptorUSN]

Drainage. There’s a few spots and may or may not be more noticeable if you have the spray in bed liner.

---------- Post added at 02:20 PM ---------- Previous post was at 02:19 PM ----------

By the way PSU as in We Are?

 

[DrippinRaptor]

Mine is like that too, even with the factory spray in liner.

 

[PSU_Fred]

By the way PSU as in We Are?

penn state!

 

[RaptorUSN]

penn state!

Nice! Same here

 

[PSU_Fred]

Supposed to be that way, allows water to drain.

Thanks. I didn't notice before. I do have the factory spray-in. I recently got a cap for the bed, and the light shining through was very noticeable inside the dark bed.

 

[jabroni619]

So was your friend able to do everything you did better?

 

[rtmozingo]

So was your friend able to do everything you did better?

Based on the performance of the Power Wagon yesterday, I'm guessing the answer is no.

 

[PSU_Fred]

So was your friend able to do everything you did better?

Well, I easily climbed some sand dunes that he slid on.
We both climbed the waterfall, but I left a 16 inch strip of powder coat from my passenger running board. Raptor was just too wide to make it clean. (Fortunately the paint was not touched.)