Ford OEM Bed Extender Locking Pins

[13raptorcrew]

I just snagged up a one-piece extender from an older truck to not deal with the pins for the hinges and connection. To each his own

 

[NM156]

Mine didn't go into the holes/grommets after the linex went on. So I popped the grommets out filed down the linex to fully seat the grommet. Now it goes it with a minimal of effort.

 

[155mm]

I kick the pins in if I need to lock the extender in position. It doesn't take a hard kick, just a few taps with the boot.

 

[WareWolf]

I kick the pins in if I need to lock the extender in position. It doesn't take a hard kick, just a few taps with the boot.

I think I will need to probably shave the liner down from inside the Locking pin holes in the bed, then shave or remove the feet so it angles properly.

Sent from my SHIELD Tablet using Tapatalk