Factory Race series 3.0’s - Non Live valve(2017/2018)

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

2slo4u

Full Access Member
Joined
Jul 23, 2017
Posts
711
Reaction score
1,456
Location
Utah
If you used the factory washers for the top hat, check the top fasteners often. They easily work themselves loose if you off-road a lot. Which will then make the holes oval.

Get them revalved with a “ flutter stack” when you go to rebuild them. You will barely notice washboard roads after that
 
OP
OP
criminal

criminal

Member
Joined
Nov 24, 2024
Posts
42
Reaction score
19
Location
Texas
If you used the factory washers for the top hat, check the top fasteners often. They easily work themselves loose if you off-road a lot. Which will then make the holes oval.

Get them revalved with a “ flutter stack” when you go to rebuild them. You will barely notice washboard roads after that
I’m seeing this around quite a bit about the hardware coming loose. I will definitely be keeping any eye on them.
 
OP
OP
criminal

criminal

Member
Joined
Nov 24, 2024
Posts
42
Reaction score
19
Location
Texas
Welp throwing my settings in here I suppose. 6/3 in front 12/10 10/12. Deaver HD +3 in rear. See how this feels for a bit.
 
OP
OP
criminal

criminal

Member
Joined
Nov 24, 2024
Posts
42
Reaction score
19
Location
Texas
how much off road driving vs. on road driving is done when looking at this sheet?
Well…realistically - I would say for me it’s 60/40 on road vs off. I’ve set the front to factory but have rears at 14/12 12/14. I just mob around like a tank and any road condition is soaked up. I’ve also had it on a track with jumps and no bottoming out either.
 
Top