GEN 2 anybody done RPG 3" collars w 4+ deavers?

[t2w]

anyone on here done this setup? was going to go this route but curious if anyone has any feedback or pictures prior to pulling the trigger.

thanks in advance!


Sent from my iPhone using Tapatalk

 

[MajorAR]

We've done several sets of 3" collars and +3 Deavers, which looks amazing, but never +4s.


Sent from my iPhone using Tapatalk

 

[Aaron]

Sometimes you just have to be the first one.

Dooo it.

 

[FadedSS]

We've done several sets of 3" collars and +3 Deavers, which looks amazing, but never +4s.


Sent from my iPhone using Tapatalk

This is what I'm planning on. Do you have pics/measurements of this setup?

 

[MajorAR]

I had them written down, but have misplaced them. I can get new measurements next week as we have another 3" collar and Deaver +3 install next Wednesday.

 

[FadedSS]

I had them written down, but have misplaced them. I can get new measurements next week as we have another 3" collar and Deaver +3 install next Wednesday.

That would be great, thanks man!

 

[Sitdown]

For the OP considering the +4s, if you plan to run a decent load in the bed and a 3" collar or equiv, i'd say do it. Can always run a shackle to lower it and gain more travel. Kinda wishing i went this route...

With +3s and 3" collar, I'm at ~42.125 (1/8-1/4" variances) at all for corners ground to fender... I expect the rear to settle some though

 

[Addictive Desert Designs]

3" leveling collar, 37s & stock rear:

 

[solarwinds]

^ **** up ass down mode.

---------- Post added at 04:33 PM ---------- Previous post was at 04:11 PM ----------

i'm ass up **** down mode with rpg 1.5 and deaver 3 even with a lot of weight in ass. rpg 1.5 is more like 1"ish and deavers +3 are like 2.75
i'm 0.5" ass high

 

[Addictive Desert Designs]

Yes but a +2.75 will only give you .75" of lift since you remove the factory 2" block. So you prob got 1" total lift in front & .75" in rear right? Looks good either way!