TheDoubleAA
Full Access Member
sorry for lax responses I've been busy putting Rob's Truck back together and working on a few other ideas. The center part of the cupholder will be customizable for whatever you want with in reason as it is a pain to put alot of detail in such a small area.
---------- Post added at 05:08 PM ---------- Previous post was at 04:58 PM ----------
So I've finally finished up the design that I like on the front cup holder but will have to figure out a way to get them done quicker as I'm spending over an hour on each one and that won't be cost effective.
As for the rear cup ambient light systems I've got a few ideas.
This is a miniature glowing disc in the cup holders that give off a light glow and will light up clear liquids etc...
This is the rear B pillar design I'm working on that I really like as they will be customizable and look very sharp. Just need to tune them down a bit and I have another idea that will make them look even better
---------- Post added at 05:08 PM ---------- Previous post was at 04:58 PM ----------
So I've finally finished up the design that I like on the front cup holder but will have to figure out a way to get them done quicker as I'm spending over an hour on each one and that won't be cost effective.
As for the rear cup ambient light systems I've got a few ideas.
This is a miniature glowing disc in the cup holders that give off a light glow and will light up clear liquids etc...
This is the rear B pillar design I'm working on that I really like as they will be customizable and look very sharp. Just need to tune them down a bit and I have another idea that will make them look even better