2013 RPG Offroad Raptor Build

[BenBB]

Hopefully this list will not get any longer.

 

[Kyler Sykora]

Update on RPG Build.

So this week I was able to install the Advanced Fiberglass Concepts 2x2 fenders with liners. Liners were also Line-X for extra protection. Man they look awesome. I also painted the rear fender flares and front grill to match the front. Lastly I was able to cut the tail pipe exhaust to get ready for the RPG Raceline rear bumper and dovetail cut.


View attachment 149479

View attachment 149480

View attachment 149481

View attachment 149478

View attachment 149477

I’ve been wondering how adv+2 fenders look before mid travel is installed. I’ve been nervous they would look strange / goofy. But yours looked good in these pictures. Did they look good in person or did it look like a truck that was missing some width?

 

[Tx4r11]

The ADV +2 fenders did look good on the Raptor without the mid travel kit. Just remember I upgraded to zero offset wheels. That added extra width to the truck. If you are using stock wheels the fenders will look a bit goofy in my opinion on the truck.

 

[Tx4r11]

Well I’m back with the TSW boys again. Let’s see what we can upgrade on this trip.

 

[Tx4r11]

Made it back from TSW Offroad late last week. These guys are great to work with and were able to complete some great upgrades for me. We started by adjusting the front coils to even the load out. Next we got two CBR trans coolers added to the RPG RST18 rack. In addition the RPG RST18 rack was welded to the RPG bed support. The guys from TSW fabricated a section on the passenger side of the bed to run two 5 gallon cans. Next we added RPG billet traction bars in Fox orange. Lastly I had the RCV axles removed and sent off for inspection and installed some axle plugs fabricated by TSW Offroad. I may just run two wheel drive for a while since I usually daily drive my truck. Unfortunately I am already looking at scheduling another future appointment. The goal for the next visit is to add a Howe pump and a CBR radiator.

 

[Brad12]

Looking good! How did you run the lines for the trans coolers?

 

[Tx4r11]

Lines were ran along the rack towards the driver-side and then down under the bed.

 

[Goliath101]

@Tx4r11 are you selling your truck? I think I saw it on the desert trucks insta page. Surprised if you are considering how much work you’ve put into it. One of my favorite 1st gen builds.

 

[Tx4r11]

Yes I did put it up for sale. We will see if it sells if not I’ll just hang on to it and add more mods.

 

[blaiseam]

You end up selling it???