Thanks! I may try their new "smoke" color. It may match the existing badging better.
Or... I may just blackout the existing badges.
---------- Post added at 10:15 PM ---------- Previous post was at 10:08 PM ----------
I should have taken pics along the way... sorry guys. I just had no idea how it would turn out... so I didn't.
This was an EASY mod. The hardest part was masking off the camera housing.
I did not remove anything from the truck.
I masked the entire badge by running maskingtape between the badge and the tailgate all the way around the oval. Very easy to do. Then masked the camera... this was a bit tedious.
I then just put a piece of tape over the blue part of the emblem, and went to town.
I did about 6 coats. 20 min between coats.... I was detailing the wife's car between coats so the time went by fast.
Once it dried I removed the mask from the tailgate, and then removed the peice of tape over the oval.
That left me with a non-plastidipped rectangle in the middle of the emblem. Using my finger I started rolling up the plastidip until I could grab it... and started peeling.
Because there is a gap between the emblem and the bezel... the plastidip self cut a perfect oval.
Kinda hard to explain, but basically whenever there is a gap, the plastidip will always cut along the gap edge.
Very easy mod.