They are 8mm long. Pretty hard to find. I priced out McMaster Carr, and by the time I got bolts, washers, and shipping, the price was comparable to the nicer flanged method bolts that dont need a washer. method, however told me, "They had no way to ship me bolts out on the east coast, so I would have to source them elsewhere." method wheels can kiss my ass.
What did you do to your Raptor today? (Gen2)
- Thread starter Jepper
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
They are 8mm long. Pretty hard to find. I priced out McMaster Carr, and by the time I got bolts, washers, and shipping, the price was comparable to the nicer flanged method bolts that dont need a washer. method, however told me, "They had no way to ship me bolts out on the east coast, so I would have to source them elsewhere." method wheels can kiss my ass.
Purchased the ProClip mounting system for my phone. A little pricey, but I wanted something pretty solid and was in a good location. I didn't want a cup holder type, nor did I want something that stuck to the windshield. This model seems to have gotten really good reviews and many have used it. So I'm hoping this works out well. Should arrive this weekend!
Rjp4419
Active Member
I removed the front plate holder and put in the Lowe’s 3/16” nylon plugs as described a couple pages back. Super easy. I was surprised the rivets were aluminum. I had been expecting plastic I guess.
I did add a dab of plumbers goop to each plug. Not sure it was necessary.
I did add a dab of plumbers goop to each plug. Not sure it was necessary.
After reading a few threads on it, I finally took a drill to my front end and drilled out the rivets holding the ugly and obstructionist front plate bracket on. Good riddance, that thing is just gross.
I followed the forum's advice and picked up two little nylon plugs at Lowe's for like $1, they fit perfectly, and really don't need any paint, as they blend in well.
I also added a bit of flair to the front doors, fighting forward!
Where did you buy the flag from?
Sent from my iPhone using Tapatalk
nikhsub1
FRF Addict
Installed the Fox Factory rears finally.
VolksDragon
Member
- Joined
- Jan 17, 2016
- Posts
- 22
- Reaction score
- 35
Yoonek Graphics on Amazon, here's the direct link:
https://yoonekgraphics.com/products/american-flag-set-left-and-right-facing-816
Rjp4419
Active Member
Installed my stubby antenna and rear seat latch
What size is that one? Cause that’s a pretty perfect size
Sent from my iPhone using Tapatalk
Similar threads
