What did you do to your Raptor today? (Gen2)

[zombiekiller]

Can’t wait to see that thing tomorrow when I’m at TMW

it'll definitely be there, hanging out on the lift.

 

[Leftsidej]

I'll just leave this here...


(yes, That is a 40. yes, that is full droop. gonna be a lot of work to clear when that tire moves 16-17" UP from this position.)

My god that’s massive. Is that a raptor only shop you’re at?! LOL.

 

[zombiekiller]

My god that’s massive. Is that a raptor only shop you’re at?! LOL.

i'd say that roughly 90% of the trucks that roll into tmx are raptors.

 

[Turbogoat324]

I'll just leave this here...


(yes, That is a 40. yes, that is full droop. gonna be a lot of work to clear when that tire moves 16-17" UP from this position.)

You’re crazy...I love it! Can’t wait to see that thing ripping!

 

[NHbeast]

Changed the oil/filter and rotated the tires...those suckers are heavy.

Done shade tree (in parking lot with tree) mechanic style.

 

[Badgertits]

Installed a Swarf works license plate bracket to open up the IC grill for more air flow. Unfortunately I forgot I had inadvertently tried to screw a plate in @ the top when purchased new mistaking the rivets for holes (actually didn’t really look hard just assumed & you know what they say bout that) - so tried drilling em out but they were spinning too much to make it happen. Plan on pulling out & squishing rivet heads flat then sawing off carefully or just removing bumper & punching out @ which point may as well get it done in Linex.

The swarf plate bracket is top notch - and should be for the price. On the fence on whether to leave plate as-is or add a black “raptor” frame w/ it

View attachment 128109

 

[Yoshi]

Installed a Swarf works license plate bracket to open up the IC grill for more air flow. Unfortunately I forgot I had inadvertently tried to screw a plate in @ the top when purchased new mistaking the rivets for holes (actually didn’t really look hard just assumed & you know what they say bout that) - so tried drilling em out but they were spinning too much to make it happen. Plan on pulling out & squishing rivet heads flat then sawing off carefully or just removing bumper & punching out @ which point may as well get it done in Linex.

The swarf plate bracket is top notch - and should be for the price. On the fence on whether to leave plate as-is or add a black “raptor” frame w/ it

View attachment 128109

View attachment 128110

View attachment 128111

FYI. If you remove the bumper grill, the clips that hold it on bend and break off, you can't buy the clips separately, you have to buy a new bumper grill. I found out the hard way when I removed it to install ppf on my bumper.

 

[singh3204]

i put in a cold air intake. i can definitely tell the difference.

 

[Mbdurham]

Had the Eibach springs installed! Thanks Nick@Apollo-Optics

It’s is perfectly level per my both my iPhone level and traditional level on the bed as well as running boards. I measured not in the driveway but in my garage. Front ground to fender measurement is now 42” and rear is 41 3/4” I am sure they will settle some.

Sorry Can’t remember what front measurement was before I measured a while back and thought I took a pic but was mistaken.


Innov8s will be going on next week [emoji16]





Sent from my iPhone using Tapatalk Pro

 

[Brad_hartpro]

Installing this bad boy tomorrow.