What did you do to your Raptor today? (Gen2)

[im33303]

Installed the Gj Motorsport 3 brake light. Amber's are wired to uplifter, clear comes on when in reverse, bed switch, and cabin switch.

Do you have a picture of the red running lights only?
Trying to see how bright are they in comparison to stock ones

 

[FordPerf Addict]

Full interior detail


Sent from my iPhone using Tapatalk

 

[FordPerf Addict]

Then the next day got it stuck in the clay and had to dig it out [emoji23]
I could not throttle out of there because it had me sliding laterally into a river.. either way I took my time and got it out just fine

Then spent 2 hours power washing the outside and wheel wells and also re cleaning my floor mats and some plastic on the inside


Sent from my iPhone using Tapatalk

 

[JohnyPython]

Finally got some decent weather after a long Canadian winter. Washed yesterday and decided to take a look at the spare.

It was pretty filthy. Gave it a power wash. Had a streak of Line-X on the rubber and it came right off. I’ll give the underside a spray too.

No wheel weights and no TPMS.

 

[Wfo]

View attachment 120944
Then the next day got it stuck in the clay and had to dig it out [emoji23]
I could not throttle out of there because it had me sliding laterally into a river.. either way I took my time and got it out just fine

Then spent 2 hours power washing the outside and wheel wells and also re cleaning my floor mats and some plastic on the inside


Sent from my iPhone using Tapatalk

Finally got some decent weather after a long Canadian winter. Washed yesterday and decided to take a look at the spare.

It was pretty filthy. Gave it a power wash. Had a streak of Line-X on the rubber and it came right off. I’ll give the underside a spray too.

No wheel weights and no TPMS.

View attachment 120945
View attachment 120946

Way to cheap out ford. Tmps and balancing would have cost too much. Wtf

 

[tmanker]

Installed the Gj Motorsport 3 brake light. Amber's are wired to uplifter, clear comes on when in reverse, bed switch, and cabin switch.View attachment 120916 View attachment 120917 View attachment 120918

How did you route the wiring? Did you have to remove the head liner?

 

[JohnyPython]

Way to cheap out ford. Tmps and balancing would have cost too much. Wtf

At least balance the spare. Finish the job FFS.

Don’t care about TPMS - more of a pain sometimes. The trade off is 5 bead lock wheels lol

 

[Boost_it638]

Do you have a picture of the red running lights only?
Trying to see how bright are they in comparison to stock ones

How did you route the wiring? Did you have to remove the head liner?

Nope didnt have to touch the head liner. Just removed the rear corner passenger trim piece, snaked the harness threw the holes of the brake light to there with a wire coat hanger. Then ran the harness under all the side trim of the passenger side up to the front passenger kicker panel. The wires to tap to the reverse and pass threw for the uplifter is located there.

 

[Simplejack]

found my old tent in attic for 2014 f150. fits good enough for my raptor.

 

[FordPerf Addict]

Stuck a blind spot mirror on.. not sure why this ain’t stock. Blind spot is terrible over my left shoulder and sometimes the sensors don’t pickup small cars or sedans right next to my B pillar. Not sure if anyone else notices


Sent from my iPhone using Tapatalk