What did you do to your Raptor today? (Gen2)

[Shane361]

Hey...
If you see E.T. down there, ask him they got any good politicians down there?

V/R,

The American People.

Bet we could fit about 10 bad ones down there...and that's a good start.

 

[jzweedyk]

He should move his truck NOW.

 

[Rick at FMS]

Last weekend I had to use 4x4 and ended up tearing the boot on the passenger side. Dealership said they would replace it under warranty but the part is on back order with no ETA. I couldn’t find it anywhere either, tried Autozone and Oreillys. Be careful if you buy from these two. Their system was showing an axle that has a smaller shaft and 3” too short. So I put a crap load of Gorilla tape as a redneck solution but just didn’t feel comfortable with it at TRR next week. My son found one and overnighted it, got it today and installed. Man it seems like I had my front end taken apart and back together soo many times, I lost track.

 

[Shane361]

Ran three zero negatives and three zero positives to my 6K Sundown Audio sub amp from the bed where my Lithium Headway battery is into the cab. It's a slow process, getting old.

 

[nikhsub1]

Replaced my driver side wheel bearing/hub assembly. I blamed my tires for a while, got new tires still had the growling noise. Went bad at around 32k miles... have 35k now. Quiet AF now and smooth as silk. Easy job too.

 

[Enersol]

I strongly disliked the stock chrome wheels. But before I spent a bunch of money on aftermarket I decided to see what it would look like pastidipped. Also, finished the off road lights on the hood and bumper. Love the backlight look.

 

[UsedRaptor]

Gonna see a lot of bikes this weekend. Big Loop enduro rally at Crystal Crane Hot Springs a couple hours north. 450 attendees. Also drove my Raptor the quarter mile to work.

 

[Chiefapple]

Any advice on getting the tailpipe section separated from the muffler section? Can’t even get it to twist.

 

[Spyderpb3]

Wife asked me to “tone down “ the trucks appearance. The bright yellow KC covers may have put her over the edge…Ended up ordering black KC vinyl overlays and am actually digging the look!View attachment 315783View attachment 315784

Dude truck looks amazing. I was reading your posts, and my Gen2 has the Eibachs up front. No Add a Leaf in the back though. You think I can still fit 37’s on my 0 offset wheels without rubbing?
I’m ok with a little fender trimming.

 

[Todd Turbo S]

Gave her a bath