What did you do to your Gen 3 today?

[Nex]

Yep. Over there and still debating on the change to the tremor or get a gen 3.5

Neither is a bad choice. Depends on your goals. I have a Carli Dominator kit on order already.

 

[Waterfowler41]

Finally a bit of free time today, knocked out a quick trailing arm upgrade. I’ll be dropping the video to my YT this week.

 

[FiveOsvt]

Finally a bit of free time today, knocked out a quick trailing arm upgrade. I’ll be dropping the video to my YT this week.

View attachment 472696View attachment 472697

Crushing it with the videos and upgrades. As far as the carbon fiber you have added from EOC, in your opinion if doing the carbon fiber hood vent only, would the hood need to be removed?. I know you removed your because you replaced the hood also but do you suspect an easy install without hood removal if just replacing the vent cowl?

 

[Waterfowler41]

Crushing it with the videos and upgrades. As far as the carbon fiber you have added from EOC, in your opinion if doing the carbon fiber hood vent only, would the hood need to be removed?. I know you removed your because you replaced the hood also but do you suspect an easy install without hood removal if just replacing the vent cowl?

Honestly, I would just remove the hood so you can get access to the vent and avoid leaning over your truck and scratching the fenders. A bit more work but there’s double stick tape on your factory vent and yours going to need to work at it to remove it. Easier to do with the hood off the truck.

 

[Wichadicha]

This is my opinion - Cover the fenders, you do not need to remove the hood! It's not the easiest removal but only take one person. The hood removal with two or more people for both removal and install might not be worth it. Just cover fenders, etc and work from both sides, you'll be fine

 

[Jafo2317]

Took my 2024 F150 801a package Raptor to the dealership where i bought it to see if the top plastic portion of the rear bumper was under the bumper to bumper warranty. The center portion just above the license plate is warped. Anyone have this issue? My truck stays parked inside my garage when not in use, so they can't say the sun was the culprit. Bought it end of June of this year and it only has 2k miles.