What did u do to your raptor today?

[Gen1TillDeath]

It’s just a sign to get RPG billet ones…. But seriously, this is for left AND right side. The only thing that’s different are the actual tie rods , the ends are the same for each side .

2010-2014 Ford F-150 Outer Tie Rod - Driver's Side (LH) AL3Z-3A130-A | TascaParts.com

2010-2014 Ford F-150 part # AL3Z-3A130-A - Outer Tie Rod - Driver's Side (LH)

www.tascaparts.com

 

[jackjare9455]

I was bored, so I went into the garage and popped in the Saudi transmission cooler. Since it’s higher than the transmission, only a few drips came out of the upper hose. There is even a convenient spot to shove the hose into to keep it from dripping. (Pictured)

It was super simple, hoses were welded on, took a few minutes to get those off, but other than that, easy peasy.

I put, maybe a quarter quart of extra Mercon LV into the cooler before connecting the top hose. Should be about right… ish… maybe. I’ll check the level at the transmission whenever I feel like having a hot converter in my face.

 

[Gen1TillDeath]

That’s how much I put in mine. But I haven’t checked the level in mine either lol. Also That’s how much forged off-road recommended to put in aswell.

 

[SJC8713]

Added more color match vinyl.

 

[rschap1]

I did my grill letters too.

 

[Meat2022]

eff me. tie rod end, out tie rods..... both point to inner tie rods. stupid. apparently its a connecting rod, and search for that and i get sway bar links.

How many miles on yours before they went out ?

 

[The Car Stereo Company]

How many miles on yours before they went out ?

this set i had replaced in 2018. about 60k miles. i havent put many offroad miles on it since then so i dont know how long these will last me

 

[Meat2022]

I think because the guy I bought mine from never went off road mine will last a while I hope, is this a pretty easy job? Alignment after you do it?

 

[jackjare9455]

Thinking about swapping my shifter for my wife’s expedition one, and seeing if she would notice. Lol

 

[The Car Stereo Company]

I think because the guy I bought mine from never went off road mine will last a while I hope, is this a pretty easy job? Alignment after you do it?

just need the press to replace.