What did u do to your raptor today?

[mprice1234]

Put some graphics on. Now, even the prius drivers will know what just passed them. They can read 'em from eye level. ;-)

View attachment 166315 View attachment 166317 View attachment 166318

They were dumb enough to buy a prius do you really think they are smart enough to know how to read

Love the graphic!

 

[MEIRONMAN207]

Changed out the belt, tensioner, and idler pulleys this morning. Easier than I thought it would be. Not sure I’m a fan of the updated plastic pulley on the tensioner though.




Sent from my iPhone using Tapatalk

Yes it is was...I was also going to do the tensioner, but saw the “plastic” new ones and passed. Also, looked into some billet high performance ones, but $$$$

 

[Chiefapple]

Yes it is was...I was also going to do the tensioner, but saw the “plastic” new ones and passed. Also, looked into some billet high performance ones, but $$$$

I’m pretty sure I could just buy another idler pulley and put it on the tensioner. It looks just like the idler pulleys.


Sent from my iPhone using Tapatalk

 

[98rangerdave]

Test fitting the Forged Offroad rear bumpstop kit today. Run out of time today to fully install, but looks really straight forward. The included Strike plates are a nice addition as most kits you need to purchase separately. Will post photos after fully installed.

 

[MTF]

@Chiefapple @MEIRONMAN207

The updated Tensioner is much better having gone through 5 Tensioners now.
I even tried the Thumper Tensioner but it ate up two alternators in a month and with the Whipple compressor needing to be removed when replacing the alternator, this became a $$$ learning curve.
Thumper wouldn't even help or even listen to my problem, I wound up selling it to another member on this forum that was installing it on his NA Raptor.

Livernois sells a 8 rib system with the Thumper, I guess Thumper must have removed some tension since I haven't heard any problems.
Livernois Motorsports

 

[Chiefapple]

Lights showed up today, so a quick test fit and now the plate is off to the powder coater.





Sent from my iPhone using Tapatalk

 

[Ruckus08]

Finally upgrading my cooling system: Full Race radiator, Afco dual pass heat exchanger with fans, mishimoto radiator hoses. My dang Roush lower heat exchanger brackets were rusted so bad I busted the bolt heads right off both of them...’cause nothing can EVER just be easy. Going to try to rig it until Roush sends me some new ones so I can put everything back together and start flushing the system tonight. Radiator is sexy...too bad nobody will ever see it. Y’all will have to validate me as usual I guess.

 

[ogdobber]

Put these on. Holds the lca in place much better and way easier to align



Sent from my iPhone using Tapatalk Pro

 

[98rangerdave]

Put these on. Holds the lca in place much better and way easier to align



Sent from my iPhone using Tapatalk Pro

Are those the SPC performance cams? I have a set I need to install. I have the basic cams on now. They keep losing alignment after a weekend in the dirt. Happy I have lifetime alignment at pep boys.

 

[Citizen Park]

Replaced the stock KO2s 315/70/17 with Toyo Open Country ATIII 35x12.5x17. Went with the more aggressive thread pattern side. Purchased them from SimpleTire.com without any issues.






Sent from my iPhone using Tapatalk